Powerplus POWX1365MB MINI CIRCULAR SAW 600W 85MM + MITRE GUIDE EN - Manual (Page 7)

POWX1365MB EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
9 OPERATION
9.1 Holding and switching ON/OFF
WARNING: Before engage the ON/OFF switch, check that the saw blade is
properly fitted and runs smoothly, and that the blade clamp screw (8) is well
tightened.
Connect the plug to the power supply. The LED power-on indicator (14) is illumed until the tool
is disconnect from the power mains.
9.1.1 Switching on the tool:
Push the lock-off button (6) forward with the forefinger (refer to the direction of arrow
① on Fig.
5) , depress ON/OFF switch trigger (5) firmly inwards and keep it pressed at the same time
(refer to the direction of arrow
② on Fig. 5).
When you release the trigger, the main switch returns automatically to initial position and the
tool turns off.
Warning: The saw blade continues to rotate after the tool is switched off.
9.1.2 Releasing the plunge stop
Press the rear position of safety lock button (3) downwards and keep it pressed (refer to the
direction of arrow
③ on Fig. 5).
NOTE: Pressing the safety lock button (3) unlocks the plunge cut
mechanism at the same time, so that the motor can be moved downwards.
The saw blade emerges from the tiltable protective cover (12).
9.2 Setting the guide fence
Release the lock screw for guide fence (11) on the base plate (18) and set the guide fence (g)
in the guide fence slot (10). Set a desired width and retighten the lock screw for the guide
fence (11).
9.3 Laser line generator
Warnings: Do not stare directly at the laser beam, do not deliberately aim
the beam at personnel and ensure that it is not directed towards the eye of
a person for longer than 0.25s.
When you make the line of the cut on the work piece, the laser line
generator can help you get better alignment.
The laser generator switch (2) locates at the front of safety lock button for mechanical plunge
stop (3).
Turn on: Press the laser generator switch (2) to “I” position, the laser generator (1) works.
Turn off: Press the switch (2) to “O” position again.
 Make sure line of the cut is on the work piece.
 Adjust the depth of cut as required.
 Plug in the machine and start the motor.
 When the blade is at its maximum speed (approximately 5 seconds), place the saw on the
work-piece.