Powerplus POWX311 VACUUM CLEANER WET/DRY 1000W EN - Manual (Page 6)

POWX311
EN
Copyright © 2008 VARO P a g e | 6 www.varo.com
§ Plug into the mains supply and press the ON/OFF button. The motor of the appliance starts;
you can start with vacuuming now.
§ To vacuum large quantities of liquid, from a sink or tank, etc., do not immerse tool
completely in the liquid, leave a gap at the top of the tool opening to allow an air inflow.
§ The appliance is fitted with a float valve, which stops the suction action when the container
has reached its maximum capacity or if the cleaner is overturned. There will be an increase
in motor speed. When this happens, turn the motor off and disconnect from power supply.
§ Guide the chosen nozzle on the floor surface/sink/tank to vacuum water.
§ Switch off the appliance by pressing ON/OFF button and disconnect the power plug from
the mains.
ATTENTION: Do not vacuum solvents, explosives, inflammable and/or
hazardous liquids such as petrol, oil, spirits, paint, thinners, acids etc
7.4 Auxiliary power supply:
§ To use the auxiliary power supply, lift the cover plate and plug in other appliance.
§ Note:The maximum rating for an appliance operated from the auxiliary power supply is
2000W.
8 TROUBLE SHOOTING
Fore applying any of the solutions described in the trouble shooting section, disconnect the
appliance from the mains and allow it to cool down completely.
PROBLEM
REASON SOLUTION
Vacuum power too low The suction power slide (2) is
wide open. Close the slide (2)
The floor brush (15) is
blocked Clean the floor brush (15) of
any blockage.
Dust/water container (13) is
full Empty dust/water container
(13).
Filter is diry Clean filter
Motor unit does not operate The unit is not switch on or
power cord is unplugged. Check unit is plugged in and
switched on
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
§ Regularly clean the machine housing with a soft cloth, preferably after each use.
§ Keep the ventilation slots free from dust and dirt.
§ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Do not submerge the motor housing in water!