Powerplus POWXG3023 BRUSH CUTTER 51,7CC EN - Manual (Page 5)

POWXG3012+XG3023 EN
Copyright © 2012 VARO P a g e | 5 www.varo.com
6 PETROL SAFETY WARNING
WARNING: Use extra care in handling fuels. They are flammable and the
vapours are explosive. The following points must be observed.

Use only an approved container.

Never remove the fuel cap or add fuel with the power source running. Allow engine exhaust
components to cool before refueling.

Do not smoke.

Never refuel the machine indoors.

Never store the machine or fuel containers inside, where is an open flame, such as a water
heater.

If fuel is spilled, do not attempt to start the power source, but move the machine away from
the area of spillage before starting.

Always replace and securely tighten the fuel cap after refueling.

If the tank is drained, this should be done outdoors.
7 SPECIFIC SAFETY WARNINGS

BLADE CAN RECOIL VIOLENTLY FROM MATERIAL IT CANNOT CUT – Blade can cause
you to lose arms or legs. Keep people and animals 30 feet (10 meters) away in all
directions. If blade contacts foreign objects during operation, turn off engine and allow
blade to come to a halt. Then check blade for damage. Always discard blade if it is warped
or cracked.

BLADE CATAPULTS OBJECTS THROUGH AIR - You can be blinded or injured. Wear eye,
face, and leg protection. Always clear work area of any foreign objects before using blade.
Keep people and animals 10 metres away in all directions.

BLADE COASTS AFTER THROTTLE IS RELEASED - A coasting blade can injure you or
bystanders. Before servicing the blade, always turn off engine, and be sure coasting blade
has stopped.

WARNING DO NOT USE ANY OTHER FUEL than that recommended in your manual.
Always follow instructions in the Fuel and Lubrication section of this manual. Never use
petrol unless it is properly mixed with 2-cycle engine lubricant. Permanent damage to
engine will result, voiding manufacturer’s warranty.

DO NOT USE ANY OTHER CUTTING ATTACHMENT. Only use our replacement parts and
accessories, which are designed specifically to enhance the performance and maximize the
safe operation of our products. Failure to do so may cause poor performance and possible
injury. Use only the stringhead supplied with this product. Do not use any other cutting
attachment. Use of such attachments will void your factory warranty and may result in
serious bodily injury.