Powerplus POWXG9427 SUBMERSIBLE PUMP 1100W SS EN - Manual (Page 6)

POWXG9427
EN
Copyright © 2014 VARO NV P a g e | 6 www.varo.com
12 TROUBLESHOOTING
INCIDENTS CAUSES REMEDIES
Pump does not start - No mains supply
- Floater does not switch
- Check mains supply
- Bring floater in a higher position
No flow - Inlet sieve is clogged
- Pressure hose in bent - Clean inlet sieve water jet
- Reset hose
Pump does not
switch off - Floater cannot sink down - Place pump properly on shaft ground
Insufficient flow - Inlet sieve is clogged
- Reduced pumping capacity
by dirty and abrasive water
- Clean inlet sieve
- Clean pump and replace worn-out
parts
Pump switches of
after short operating
period - Thermal cutout stops
pumps due to dirty water
- Water too hot. Thermal-
cutout stops pump
- Remove mains plug. Clean pump
and shaft
- Make sure that a water temperature
of max. 35°C is not exceed
13 STORAGE
 Thoroughly clean the whole machine and its accessories.
 Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
 Protect it from exposure to direct sunlight. Keep it in the dark, if possible.

Don’t keep it in plastic bags to avoid humidity build-up.
14 WARRANTY
 This product is warranted for a 36-month period effective from the date of purchase by the
first user.
 This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.
 Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
 We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.
 Repairs may only be carried out by an authorized customer service center for Powerplus
tools.
 You can always obtain more information at the number 00 32 3 292 92 90.
 Any transportation costs shall always be borne by the customer, unless agreed otherwise
in writing.
 At the same time, no claim can be made on the warranty if the damage of the device is the
result of negligent maintenance or overload.
 Definitely excluded from the warranty is damage resulting from fluid permeation, excessive
dust penetration, intentional damage (on purpose or by gross carelessness), inappropriate
usage (use for purposes for which the device is not suitable), incompetent usage (e.g. not
following the instructions given in the manual), inexpert assembly, lightning strike,
erroneus net voltage. This list is not exhaustive.
 Acceptance of claims under warranty can never lead to the prolongation of the warranty
period nor commencement of a new warranty period in case of a device replacement.
 Devices or parts which are replaced under the warranty therefore remain the property of
Varo NV.