Powerplus POWXG9451 PRESSURE PUMP 800W 25L EN - Manual (Page 5)

POWXG9451
EN
Copyright © 2014 VARO NV P a g e | 5 www.varo.com
8 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
8.1 Cleaning
Under normal conditions, the water pump is free of maintenance. However, the pump should
not be placed in the open air during rain, in a humid place, or dirty or frozen environment.
 Freezing, idling or blocking by impurities should be avoided.
 Always disconnect the power supply before maintenance of the pump.
 If the power cable is damaged, it must be replaced by professional personnel. Damage
caused by short circuiting is not included in scope of the guarantee.
 If trouble with the pump is experienced, guaranteed repairs must be carried out by an
authorized maintenance center.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
8.2 Cleaning of the built-in filter.
Your pump is equipped with a built-in filter. Regularly remove the dirt that fixes on the mazes
of the filter.
To clean the filter unit :
 Switch off the pump & pull plug from power supply socket

Unscrew the filter lid from it’s housing
 Take out the filter casette and clean it under running water.
 reposition the filter cassette and close the lid again, plug in the power plug and switch the
pump back on.
9 TECHNICAL DATA
Model POWXG9451
Rated Voltage 230V
Rated Frequency 50Hz
Rated Power 800W
Rated pressure 0,4 mPa –4 bar
Max. suction height 7m
Int. protection Degree IPX4
Max water temp 35°C
Lift height 40m
Cable length 1.2m
Liq. Debit (capacity) 3200l/hour
Min. diameter of suction hose 1” (25mm)
Min. diameter of pressure hose ¾” (20mm)
Contents pressure tank 25L
Material pump housing / Tank Plastic / metal
Weight 16.22Kg
Suitable for Clean water