Eclipse - Fujitsu Ten CD5425E - Manual (Page 44)

„ 108 „
Various Settings
Setting examples:
The volume for the initial FM mode (default value: 40) is used as a reference for storing the differences
in volume that have been set for each audio mode.
*:The volume levels can be set to a maximum of 80 and a minimum of 0. If you try to go past the
maximum or minimum volume level, the level will not change. For the CD changer, SVC
adjusts the volume using the setting value for the CD player.
The volume difference can be set within a range of -10 to +20.
ATTENTION
If the battery terminals have been disconnected because of a reason such as vehicle
maintenance, the SVC settings will return to their default values. If this happens, you will need to
make the settings again.
SVC (Source Volume
Control)
Adjusts different volume levels for each
audio mode. When SVC is set, the
volume level can change as shown in the
example settings in the table below.
Increases the SVC
setting level. Decreases the SVC
setting level.
LOUD
The loudness control may be turned on to
emphasize low and high frequencies at
low volume levels.
Loudness compensates for the apparent
weakness of low and high frequencies at
low volume by boosting the bass and
treble levels.
Turn the loudness control ON/OFF.
Audio mode FM AM (MW)
/LW
CD
Default value
(Volume level)
Reference
(40)
0
(40)
0
(40)
SVC setting
(Volume level)
Reference
(40)
SVC setting
value
+15 (55)
SVC setting
value
-10 (30)
When volume level in FM
mode is adjusted from 40
to 45
45 55 ➔ 60 30 ➔ 35
When volume level in CD
mode is adjusted from 35
to 60
45 ➔ 70 60 ➔ 80* 60
When volume level in AM
(MW) /LW mode is
adjusted from 80 to 20
70 ➔ 5 20 60 ➔ 0*