Excalibur electronic H638S-WC-CS User Manual
Page 2
C
ongratulations on your
purchase of The Weather
Channel® Master Light Toolbox
from Excalibur Electronics.
It combines a bright LED
fl ashlight with a utility toolbox.
It also features a powerful
mounting magnet, and with the
EZ Crank, the batteries never
need replaced!
The Weather Channel® Master
Light Toolbox is easy to use. Be
sure to keep this User’s Manual
for your reference
Your set includes :
9 Screwdriver heads
4 Precision screwdrivers
8 Socket heads
1 Hexagonal connector
1 EZ Crank handle and multitool
1 Tool extension
1 Toolbox
Features
• Flashlight with alert
• No batteries needed
• Adjustable
brightness
• 25-piece toolkit with box
• Powerful mounting magnet
Charging the Flashlight
Make sure that the Master
Light is off before charging.
Insert the EZ Crank handle
into the Winding port located
at the base of the Master Light
Toolbox. Rotate the EZ Crank
handle clockwise for three
minutes to fully charge. After
a full charge you will have
approximately 180 minutes
of bright light on the “Low”
setting, or 60 minutes on
“High”.
Note: Battery life may vary.
Operating the Flashlight
Push the Power Button on the
door to turn the fl ashlight on.
To increase the brightness of
the fl ashlight, push the power
again. Press this button a third
time to activate the fl ashing
alert light. Press it one more
time to turn the fl ashlight off.
The Weather Channel® Master
Light Toolbox features a
pivoting lamp head. To use
this feature, press the Lamp
release buttons on either side
of the LED lamp in, and pull
up on the lamp head. With the
lamp head fully extended, you
can pivot the light 180 degrees.
Using the Mounting Magnet
The Mounting magnet at the
bottom of the unit can be
used to attach the toolbox to
almost any metal surface for
convenient use.
Using the Multitool
The EZ Crank handle doubles
as a multitool that connects to
your sockets and screwdriver
heads. Insert the screwdrivier
heads directly into the end
of the multitool. To use the
sockets, insert the hexagonal
connecter into the end of the
multitool, then connect your
socket. Use the Tool extension
with sockets and screwdriver
heads to make work easier!
Safety and Care
• Avoid rough handling such
as bumping or dropping.
• Clean using only a slightly
damp
cloth.
• Do not submerge the lantern
in water or other liquids.
• For best results, use
between 39º F and 100º F
(4º C - 38º C).
• LED bulbs are not replace-
able. Do not attempt to open
light housing. Doing so could
damage the unit.
• Do not look directly into the
light. This may damage eyes.
LED lamp
with alert
Lamp release
(both sides)
EZ Crank handle
and multitool
Mounting magnet
Precision
screwdrivers
Closing clasp
Winding port
Screwdriver
heads
Socket set
Flashlight power
button (on door)
Tool extension
(behind screwdrivers)
Hexagonal
connector
H638S-WC-CS (MA) Master Light Toolbox 071707.indd 2-3
H638S-WC-CS (MA) Master Light Toolbox 071707.indd 2-3
7/17/07 6:14:05 PM
7/17/07 6:14:05 PM