EXP Computer ThinConnect4 - Manual (Page 37)

ThinConnect4 <27>
ThinConnect4 can not be found
Follow some of these steps, which may help you trouble shoot:
Check the RJ-45 connectors for the PC and ThinConnect4. The connector should not
be loose and click “Search” again.
Check if the power switch is on (The power LED should light up) and click “Search”
again.
Check if the Link Rx monitor LED in the front of ThinConnect4 is lit up.
Please refer (When Link Rx monitor lamp does not light) page 12.
Check the TCP/IP Protocol setting again.
Please refer to 2.6 Windows 95 Settings for LAN Connection (Page 13 to 19)
PC setup.
4. Choose the ThinConnect4 to setup by highlighting it and click
“Settings”.
Note: You can exit the ThinConnect4 utility by clicking on “Close” at any time.