Electrolux EWF 14480 W - Manual (Page 16)

16 electrolux use
Cancelling a programme
Turn the selector dial to O to cancel a
programme which is running. Now you
can select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
pressing the Start/Pause button.
If the “door”
light goes off, the
door can be opened.
If the “door”
light does not goes
off, this means that the machine is
already heating, that the water level is
above the bottom edge of the door or
that the drum is turning.
In this case the door can not be
opened.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
to O. After about 3 minutes the door
can be opened (pay attention to the
water level and temperature!).
At the end of the programme
The machine stops automatically and a
flashing “
0.00 ” will appear on the.
If the Rinse Hold” or Night Cycle
options have been selected, the
“door” pilot light illuminates, a
flashing “ 0.00 ” will appear on the
display, the Start/Pause light goes off
and the door remains locked to
indicate that the water must be
emptied out before opening the door.
To empty out the water please read
the steps on the Night Cycle option
paragraph.
Turn the programme selector dial to
“O” to switch the machine off. Remove
the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
132969890_GB.qxd 05/09/2007 10.15 Pagina 16