Essick Air 826 800 - Manual (Page 3)

HOW YOUR HUMIDIFIER WORKS
LEGEND:
1. Water reservoir
2. Chassis/power pack
(motor/fan assembly)
3. Evaporative wick
4. Dry air intake
5. Moist air output
Dry air is drawn into
the humidifier though
the back and
moisturized as it
passes through the
evaporative wick. It
is then fanned out
into the room.
CAUTION: Do NOT position
the unit directly in front of
a hot air duct or radiator. Do
NOT place on soft carpet.
ASSEMBLY, CONTROLS & OPERATION
1. Unpack humidifier from carton.
2. Remove all packaging materials. Check to see that you have all of the following items removed from the
boxes accessory kit and cabinet before discarding the packaging:
♦ Evaporative wick ♦ Caster kit
♦
Lift rod assembly with Styrofoam float
CASTERS
3. Turn the emptied cabinet upside down. Insert each caster stem into the four caster holes on each
corner of the humidifier bottom. The casters should fit snugly and be inserted until the stem shoulder
reaches the cabinet surface.
4. Turn the cabinet right side up.
EVAPORATIVE WICK
5. Replace the float assembly and attached lift rod into
the boxed area on the bottom of the inside of the
cabinet. Slip lift rod into retainer ring and twist to
secure. The lift rod should be able to freely move
up and down about 3/8”. The retainer ring should be
located between the two ribs on the lift rod.
6. Place the wick assembly back into the guides
provided in the bottom of the cabinet and the ribs along the sides.
7. Place the chassis unit onto the cabinet ensuring that the chassis seats correctly into the front and back
grooved edges.