Euro-Pro KP170E - Manual (Page 3)

Operating Instructions
Attention: Allow at least 2 minutes
between the time the Chill
function is turned off and
restarted to keep from
damaging the unit.
Wash each part of the unit which touches
the ingredients, such as the Stirring
Paddle, Ice Cream Scoop, Lid, and the
Removable Ice Cream bucket. Parts
should be washed with hot water and a
mild dish washing detergent and wiped
completely dry. Do NOT use abrasive
cleaners to clean as these may damage
your appliance.
Note: Clock display is in the 24 hour
time format (i.e 4:00pm will be
displayed as 16:00. The clock
does not display in AM/PM
format.
1. Plug the unit into a properly grounded
outlet. 12:00 will be displayed.
2. Press the Clock button and the "12"
will begin to flash.
3. Press the Setup button until the correct
hour is displayed (i.e. "20" for 8PM).
4. Press the Clock button again and the "00"
will flash.
5. Press the Setup button to advance the
minutes setting to the desired minutes.
6. Press Clock button again and your clock is
set.
7. Repeat the above to set your clock in the
case of a power failure, time change, etc.
Before First Use
Clock Set Up
1. The time it will take to make ice
cream will be different depending
on the recipe, amount of
ingredients and room air
temperature.
2. To extend the life of the unit, do
not allow the ice cream to freeze
and jam the motor. If the motor
jams, push the Chill/Off button.
3. The Lid, Stirring Paddle, and Ice
Cream Scoop are TOP RACK
dishwasher safe. The Removable
Ice Cream Bucket may be placed
in the LOWER RACK of the
dishwasher.
4. To attain the best performance
from the unit, always ensure that
the Cooling Cylinder and
Removable Ice Cream Bucket are
completely dry before starting to
chill.
5. For optimum performance, always
make sure that the Removable Ice
Cream Bucket is completely
seated in the cooling cylinder.
6. To maintain optimum performance
and to prevent damaging the unit,
always store in a horizontal
position, as it would during use
7. Make sure that there is at least 8 -
10 inches of free space on all
sides of the ice cream maker to
allow for adequate air circulation.
User Tips
3
OPERATING INSTRUCTIONS
Making Ice Cream
1. Place unit on a flat level surface with no
walls or objects within 8-10 inches of all
sides of the unit.
2. Prepare your ingredients as per recipe. Do
not fill the Removable Ice Cream Bucket
with more than 1 Quart of ingredients.
3. Press the Setup button and :65 (minutes)
will flash. Continue to press the setup
button until the desired preparation time is
displayed(this time should include 15
minutes cooling time and the mixing
time).
Hint: Always have motor assembly in
place for optimum cooling performance.
4. Press the "Chill/Off" to start the chill cycle.
5. After 15min. a buzzer will sound and the
unit will be ready to start the mixing cycle.
6. Remove the motor assembly.
7. Add your recipe ingredients to the
Removable Ice Cream Bucket and press
the Bucket firmly into the cooling cylinder
.
8. Replace the motor assembly with
Stirring Paddle in place. Motor assembly
must be completely seated in place or the
unit will not mix.
9. Start the mixing cycle by
depressing the Mix button. (If the
mixing cycle must be terminated at
any time you just have to press the
mix button to stop mixing).
10. Do not allow the ice cream mixture
to freeze and lock the Stirring
Paddle. If the Stirring Paddle does
become locked, immediately press
the Chill/Off button to keep from
damaging the unit.
11. When the ice cream is ready, turn
unit "Off" by pressing the Chill/Off
button.
12. Remove the motor assembly from
the unit.
13. Remove the Removable Ice Cream
Bucket from the unit and empty the
ice cream into another container. If
you do not wish to use the ice
cream right away, cover the ice
cream container and place it in the
freezer. If the ice cream is too soft
after it has finished mixing. Just
place it in the freezer for 1 - 2
hours.
There are four function buttons on the digital control panel: Chill/Off, Mix, Clock, Setup.
DIGITAL CONTROL PANEL
Chill/Off: Press to start the "Chill" cycle
or to stop the unit during the
"Mixing" cycle.
Mix: To start the unit mixing, press
the "Mix" button. To stop,
press "Mix" again.
Clock: The LCD display shows the
time. To adjust the clock, press
"Time" for the "hour" to flash
and then press "Setup" to
adjust the hour. To adjust
the minute setting, press the
"Time" button until the minutes
flash and then the "Setup"
button to adjust accordingly.
When you have finished
setting the correct time, press
"Time" button again to set.
Setup: Press to set the cycle timer or
set time.
4