Euro-Pro 372H - Manual (Page 18)

HE MMING (Model 377 only)
P re s s e r foot
P a tte rn s e le c tor
S titc h le ngth dia l
he mme r foot
M ( )
1 to 4
R ais e the foot and the needle to its highes t pos ition. R eplace the
foot with the hemmer foot.
F old over the fabric edge by about 3mm (1/8 inches ) and place it
under the foot. S ecure the folded edge with a few s titches . Take
out the workpiece and draw the hem into the hemmer foot by
pulling on the threads .
Lower the foot and s we the hem.
During s ewing, fold the fabric to the left a little and allow it to
run into the hemmer foot.
Make s ure that the fabric does not move under the right half of
the foot. T he fabric mus t be fed into the s croll of the hemmer
s ufficiently s o that the workpiece edge runs freely through the
groove under the foot.
hemmer foot
3mm
S E WING B L IND HE MS (Model 377/374/373/372/372H)
M odel 377 M odel 373/372/372H M odel 374
blind hem foot
Pattern selector
Presser foot
S titch length dial
1 to 3
B ( ) E ( )
blind hem foot
1 to 3
1. T urn up the hem to the desired width and press. ( F ig. 1)
2. F old hem back against the right side of the garment with
top edge of hem extending about 4 mm (1/6 inches) to the
right side of the garment folded. (F ig. 2)
3. P lace the garment under the foot so that double-folded edge
runs along the hemlguide and lower the foot.
S ew slowly for better control, making sure the narrow
zigzag stitches are sewn on the hem edge and wide zigzag
stitches will just catch one thread of folded edge. (F ig. 3)
4. Unfold the fabric and you will have a bling stitch hem
(F ig. 4)
(F ig. 1)
,,
4mm (1/6 )
(F ig. 2)
(F ig. 1)
G uide
a djus ting
s cre w
G uide
(F ig. 3)
(F ig. 4)
F oide d e dge
16