Elmo PSS 6U - Manual (Page 14)

Elmo PSS User Guide
MAN-PSSUG (Ver. 3.01)
3-1
Chapter 3: Installation
3.1 Unpacking the System Components
To unpack the PSS:
Carefully remove the power supply from the box and the Styrofoam.
1. Check the supply to ensure that there is no visible damage to the instrument. If any
damage has occurred, report immediately to the carrier that delivered your product.
2. To ensure that the PSS you have unpacked is the appropriate type for your
requirements, find the part number sticker on the side of the supply:
The P/N number in the middle gives the type designation as follows:
PSS F - 20 / 200 R
Rated Current
H = Horizontal Panel
Fan Cooling Required
Shunt Regulator
Power Supply
-
Output Voltage
R = Rack
Mounting:
3. Verify that the PSS model is the one that you ordered, and ensure that the voltage
meets your specific requirements.
3.2 Mounting and Wiring the PSS
For optimum heat dissipation, the power supply should be installed with the heatsink
fins in the vertical direction.
3.2.1 Wiring Guidelines
1. Use flexible wires with the proper cross-section to handle the unit current. Color
coding is recommended.
2. After wiring is completed, carefully inspect all conditions in order to ensure
tightness.
3.2.2 AC Power Supplies
The PSS power supplies do not include inrush current control. Therefore, they
should be connected to an isolating/floating transformer.
ELMO
PSSF-20/200H
S/N:PSS2055016