Eurotech Appliances 3200 - Manual (Page 4)

4
Scrape the spill or melted material from the hot cooking
zone onto a cold area of the cooktop. Then turn off the
burners, allow the unit to cool (note that the “HOT”
indicator light is out), and clean according to “Normal
Care” outlined above.
Cleaning Burned-on Spillovers – First, be sure the
“HOT” indicator light is off and the surface is cool.
Remove the burned-on substance with a single-edged
razor scraper. Hold the scraper at approximately a 30
°
angle to the cooktop and scrape as you would paint off a
window. Complete the cleanup by following the “Normal
Care” procedure outlined above.
Removing Metal Marks – It may happen, particularly if
you use thin gauge metal cookware, that there will be
marks on your cooktop, resulting from metal rub-off.
These marks often appear as scratches but are easily
removed using the procedure for “Spillovers” described
earlier. For unusually stubborn marks, use cleaning cream
in conjunction with a razor scraper.
Cleaning Creams – There are creams formulated
specifically to clean ceramic-glass cooktops such as the
Origo Eurotech models. Look for them in the housewares
section of grocery stores, merchandise stores, home
improvement and appliance stores, and kitchen and bath
stores. The most common cleaning creams are:
ELCO CLEANING CRÈME
(Elco Laboratories, 800-872-8854)
GOLDEN VENTURES CERAMA BRYTE
(Golden ventures, 317-872-2705)
HOPE’S COOKTOP CLEANING CREAM
Service
First, before requesting service on your Origo Eurotech
ceramic cooktop, the following simple checks may save
you inconvenience and expense.
Presuming that the appliance is not working at all, or not
working satisfactorily, first check:
• Electricity is properly connected, circuit breaker is on
and the knob is turned on.
• Pan and cooktop surface are clean and dry.
• Cooking pan is the correct size and positioned
correctly over the element.
• The pan has a flat and even bottom surface.
• The control setting is correct.
Next, CONTACT ORIGO (or its agent) prior to having
any service work performed. Be prepared to furnish the
model and serial number as indicated on the label
located on the underside of the cooktop´s outer case.
You will be given instructions where to send or take the
appliance, as well as a determination of warranty
eligibility.
Should the cooktop require removal, insure power is OFF
at the main breaker panel. Do not remove the electrical
cable from within the appliance. Instead, disconnect the
electrical cable at the external junction box.
ORIGO AB SWEDEN
1540 Northgate Blvd.
Sarasota, FL 34234
USA
Phone (941) 355 4488
Fax (941) 355 1558
Email: [email protected] VREDBAND IMPORT, INC.
1855 A, Boul. Industriel
Chomedey, Laval Qc.H7S 1P5
CANADA
Phone (450) 668 3111
Fax (450) 668 6270
Manufactured by
DOMETIC ORIGO AB
Internet www.origo-sweden.com
Phone +4635 16 57 00 Fax +4635 16 57 10
Söndrumsvägen 35, SE - 302 39 Halmstad Sweden