Euro-Pro SHARK TRAILBLAZER EP825 User Manual

Never reuse paper bags, Upright vacuum item # xsg825

Advertising

Upright Vacuum

Item # XSG825

for Model EP825

Upright Vacuum

Item # XSG825

for Model EP825

10 Paper Bags – 2 Belts – 1 Bulb

Warning:

To reduce the risk of electric shock, the power cord

must be disconnected before changing the bag or

performing maintenance/trouble shooting checks.

Warning:

To reduce the risk of electric shock, the power cord

must be disconnected before changing the bag or

performing maintenance/trouble shooting checks.

Changing the Dust Bag:

A) Unplug power cord from wall outlet.
B) Remove the front panel of the unit.
C) Remove the old dust bag by holding the cardboard tab and pull

towards you. Remove carefully to avoid dust/dirt spilling from dust
bag.

D) Take a new dust bag and while holding the cardboard tab push the bag

over the opening of the dirt discharge tube until it is seated against the
rear of the enclosure.

E) Make sure that the entire bag is inside the housing, before replacing

the front panel. Always check the pre-motor and post motor filters
every time you change the dust bag.

F) Once the new dust bag is in place, replace the front panel by aligning

the bottom locking tabs with the slots in the body, close cover slowly
allowing the front panel to snap in place. The latch will self lock.