Remove transport packaging, Description of the appliance, Disposal of old appliances – Electrolux C 6 18 41 i User Manual

Page 23

Advertising
background image

6

Remove transport packaging

The appliance and the interior fittings are protected for transport.

• Remove all adhesive tape and packing pieces from the interior of the

appliance.

Disposal of old Appliances

For environmental reasons, refrigeration appliances must be disposed of
properly. This applies to your old appliance, and - at the end of its service
life - to your new appliance as well.

Warning! Before disposing of old appliances make them inoperable.
Remove plug from mains, sever the power cable, remove or destroy any
snap or latch closures, to prevent small children being trapped inside.

• Use an authorised disposal site.
Contact your Local Council or Environmental Health Office to see if there
are facilities in your area to recycle the appliance.

Description of the appliance

A - Dairy compartment
B - Can storage shelves
C - Bottle storage shelf
D - Thermostat control
E - Glass shelves
F - Glass shelf
G - Salad drawers
H - Compartment for

freezing fresh food

I - Compartments for

storing frozen food

A

B

D

C

I

H

G

F

E

23

Open the appliance door and the fur-
niture door at 90°. Insert the small
square (B) into guide (A). Put togeth-
er the appliance door and the furni-
ture door and mark the holes as indi-
cated in the figure. Remove the
squares and drill holes with ø 2 mm
at 8 mm from the outer edge of the
door. Place the small square on the
guide again and fix it with the screws
supplied.

8mm

PR167

A

B

PR168

At the end of installation/adjusting, it
is necessary to check if the door of
the furniture closes properly.
Should adjustment of the furniture
door be necessary, use the clearance
of slots.

PR33

C

A

Fix cover (C) on guide (A) until it clips
into place.

Advertising