Electrolux LAVATHERM 37700 - Manual (Page 7)

Important Safety Information
7
Erection and connection
• Please follow the separate Installation and connection instructions.
If necessary get some advice from your local chimney sweep or
building authorities.
• If the tumble drier has to be carried, first remove the base strip!
• Check the tumble drier fortransport damages. Under no
circumstances should you connect a damaged appliance! Please
contact your supplier in the event of damages.
• Do not install the tumble drier in rooms which are in danger of
freezing!
• Install the tumble drier level!
• When installed next to a gas, coal or electric heater: a heat
insulating, non-flammable board must be inserted (dimensions:
85x57.5 cm).
• The plug of the appliance must be freely accessible after installation.
• The outgoing air from the tumble drier may not be led into a smoke
or chimney flute.
• Do not lead the outgoing air into a shaft which serves to ventilate
rooms in which heating is installed.
• Do not install the tumble drier in a room in which heaters with coal
and oil connected to a chimney are located in which the under
pressure is 0.04mbar or more.
• Provide sufficient ventilation to avoid underpressure from forming.
• In accordance with the technical connection conditions of the power
utilities, a permanent connection to the power supply may only be
made by an authorised electrician.
• The dryer sucks in air. You should therefore keep the area around the
appliance clean and also not store any flammable items that may be
sucked into the appliance (e.g. cat litter, shavings) in front of it. There
is risk of fire!