Elta 2444MP3 - Manual (Page 18)

INSTALLATION
FOR TABLE TOP
•
Put the main unit and the speaker on a
piece of soft cloth, which for preventing
scratches the unit front panel.
• Use your finger press on the decoration
part, which are at the groove of the main
unit rear cabinet and slide down to release
away it from the groove.
• Insert the support plate into the groove.
• Slide up the support plate until it is locked.
• If you put your equipment on a glass table
or a very smooth surface. The main unit
and speaker box would be easy to move by
hand pushing. You could insert the rubber
sleeve to the bottom of the support plate.
• This product is designed both for placing
vertically and horizontally. Removing the
support plate away for horizontal placing.
The display can be rotated staying in 1 of 3
kind of viewing angle (30º, 60º, 90º) as you
like.
FOR WALL MOUNTING:
1.
Use the wall-mounting template supplied
with unit to make anchor hole marks on
the wall. Make sure the marks are
leveled.
2. Drill 3/16" holes on the marks.
3. Insert the plastic anchor supplied with
unit through the hole and tap it until it is
flush with the wall.
4. Inset the screw and tighten the screw
3mm sway from the wall.
5. Hang the main unit and the speakers to
the screw.
018.
RUBBER SLEEVE
SUPPORT
PLATE
SLIDE DOWN THE
DECORATING PART TO
REMOVE FROM MAIN
UNIT REAR CABINET
Screw
Plastic Anchor
2444MP3 DE,GB,FR &HR 9/7/05 3:29 PM Page 018