Extron Electronics DAV_DAS101CM - Manual (Page 6)

DAV101CM, DAS101CM • Quick Start Guide
Quick Start Guide — DAV/DAS101CM, cont’d
iv
Step 3
For wall/furniture or rack installations, attach the module(s) to a
CPM Series mini architectural adapter plate (MAAP) frame or to a
rack-mountable frame. See pages 2-3 and 2-4.
Step 4
Attach the front panel input cable(s).
Step 5
Verify correct cabling and connector wiring and test the system:
power on all the devices and monitor the audio/video output.
Each DAV module’s Power LED is lit while the unit receives power.
If needed, power off the devices, disconnect the
modules’ power supply, correct cabling or wiring
errors, then restore power.
Step 6
For a DAV101CM, set the sharpness/peaking
control using a small screwdriver, as shown at
right. See page 2–8 .
Step 7
Disconnect power from the module(s) and
other devices.
Step 8
For wall or furniture mounting, mount the
modular connector frame and module(s) to
the wall or furniture.
For device mounting, mount the module(s) to the device’s faceplate.
For rack mounting, mount the rack-mountable frame to the
equipment rack.
See
pages 2-9 and 2-10 . For all installations, place the connector plate
onto/against the mounting surface and secure it to wall, furniture,
device, or rack with the provided screws or bolts. Be careful not to
damage the cables.
Step 9
Restore power to the devices. You have completed the installation.
DA
V1
01C
M
VGA LINE DRIVER
VID
EO
IN
PU
T
PO
WE
R
PE
AK
ING
Peaking