Kichler 300124 - Manual (Page 8)

7
Fig. 9
9. ATTACHING THE FAN BLADES
Fig. 10
Step 1. Attach a blade to a blade bracket using
the screws, metal washers and fiber washers
provided. (Fig. 9)
Make sure the blade is straight when set on
the blade bracket. Tighten each mounting
screw and then repeat this procedure for each
blade.
Step 2. Attach each blade assembly to the
motor using the "Pre-Installed" mounting
screws in the blade bracket. (Fig. 9)
Set of blade brackets
Blades
Fiber washers
Washers
Screws
Screws
Screws
Mounting plate
Mounting ring
10. INSTALLING THE MOUNTING PLATE
1. Loosen two screws on the mounting ring
attached to the motor shaft and "remove" and
save the third screw. (Fig. 10)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 10)