Crivit Sun Lounger - Manual (Page 14)

14
Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it. Carefully read the
following instructions for use. Use the product
only as described and only for the given areas
of application. Keep these instructions safe.
When passing the product on to a third party,
always make sure that the documentation is
included.
technical details
Weight: approx. 4.3kg
Dimensions: approx. 146 x 64 x 92cm
(L x W x H)
Max. load: 100kg
Max. loading capacity when used as a transport
aid: 20kg
Scope of delivery
1 – main frame 1x
2 – footrest frame 1x
3 – sunroof 1x
4 – wheels 2x
5 – rod 2x
6 – screw long 2x
7 – screw short 2x
8 – washer 2x
9 – cap nut 2x
10 – pin 2x
11 – spanner1x
1x instructions for use
intended use
The article is not designed for commercial use.
The article is intended for use in the leisure and
camping sector (outdoor area).
Safety notice
Warning!
• Danger of suffocation for children!
• Never allow children to play with packaging
materials when unsupervised.
danger of injury!
• Do not place loads that exceed 100kg on the
beach and transport stretcher.
• Check the article before initial use for dam-
age or signs of wear and tear. Make sure that
all connecting elements are sufficiently tighten-
ed. The article may only be used when in
perfect condition!
• Tighten each individual screw before using
the beach chair.
• Place the beach chair only on solid, even
ground.
danger of Bruised Fingers!
• The beach chair may only be erected by
adults. Take care not to trap your fingers
when folding and unfolding the article.
Caution!
• Always supervise your children. The beach
chair is not a toy or a climbing aid.
Make sure that nobody stands on the head or
foot sections of the chair.
• The beach chair can also be used as a
transport aid, although it is not designed for
transporting people!
assembly
Step 1: assembling the Foot Frame
Section
The lounger needs to be folded in order to make
the assembly of the footrest frame easier. Pull
the inside rods of the lower end of the main
frame out by approximately 2cm. The holes on
the inside rods must be in the same position as
those on the footrest frame. The footrest frame
is then attached to the main frame (figure B).
The connecting rod on the main frame is now
attached to the footrest frame using the screw (6)
(figure C).
GB