Ic-7000 cam user’s guide – Edimax Technology Pan/Tilt IP Surveillance Camera IC-7000 User Manual
Page 36
`
IC-7000 CAM User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
IC-7000 USER’S GUIDE
PAGE 36/62 Rev.
PV1.0
4.4 M
OTION
D
ETECTION
S
ETUP
Setting up the Motion Detection (MD) values, including the first area (red border) and
second area (green border).
Please check whether the event trigger has been enabled or not first, then you can setup
parameters of motion detection as described below:
- Reset MD range: Select motion detect 1 or 2, and hold down on the left mouse button
(this will appear as the upper left corner of the MD range). Then, drag out the desired
range, and release when finished.
(
,
)
- Cancel MD: Same as above, but just left click once and release. This will cancel the
MD (Motion Detection).
- Motion_detec_set: This sets the MD (Motion Detection) sensitivity, which is usually set
to a value of 5. This means that the motion detection will be triggered with as little of a
5% change within the MD range. The lower the number your entered, the higher the
sensitivity of the MD.
(
) will be.
When motion is detected, the screen should display an MD warning in red in the upper
left hand corner if there is movement within MD1 or MD2, as shown in below:
- Any motion detection range can be selected in 640x480 and 320x240 resolutions