Crivit FM-1401 - Manual (Page 4)

4
Important!
Read these instructions through carefully before using this product for the first time
and afterwards retain them for future reference!
technical specifications
Maximum load: 30 kg
For bicycle frames sized 25 mm – 40 mm
Intended use
This bicycle assembly stand was developed for private use.
safety notices
risk of injury!
• Thoroughly read the assembly and operating instructions prior to assembly and follow
the individual steps as described in the assembly instructions.
• WArnInG! Do not exceed the maximum load capacity of 30 kg! Injuries or product
damages may result.
• Routinely inspect all parts on the bicycle assembly stand. Tighten loose screws and
replace defective parts to avoid product damage.
• Always ensure the Allen screws at the top pipe coupling are tightened securely.
• WArnInG! Only set up the bicycle assembly stand on solid and even surfaces to
prevent the product from tipping.
• WArnInG! Do not sit persons on the mounted bicycle. Risk of injury.
• caution! crushing hazard!
When folding and unfolding the assembly stand, take care not to pinch your fingers.
• Position the assembly stand to leave sufficient space to move around, even with the
bicycle attached.
• Avoid property damage!
To avoid damage to the bicycle avoid pinching cables and/or wiring in the assembly
stand.
• When securing carbon frames or thin-walled aluminium frames be careful to prevent
damaging the frame.
• The guide and securing components must be kept free from oil and grease.
cAutIon!
Unconventional or even improper use may put persons at risk or result in damage
to the bicycle.