Eurotech Appliances EWC177 - Manual (Page 4)

CUSTOMER CARE CENTER 800.898.1879 www.eurotechappliances.com
IMPORTANT: Retain all shipping bolts, spacers and grommets
Reinstall to prevent damage if you transport machine in the
future.
* Do not plug in power supply until shipping
bolts are removed.
3. Connect Water Inlet
If connecting to new or unused water pipes, run water until clear before
connecting to machine to remove any debris that could clog the water valve
screens. NOTE: Make sure water supply shut-off valves are
easily accessible.
IMPORTANT: Water pressure MUST be within the range of
values indicated in Specifications.
Two inlet hoses are provided with the machine. Hot water hose has red
stripe running the length of the hose. Insert washer/filter (Fig. 5A) before
connecting water inlet hose to valve. Check that other end of the hose is tight
Connect to faucet (Fig. 5A). Connect to machine (Fig. 5B).
NOTE: connect fill hoses, plastic end to machine AND metal end to water
faucet.
IMPORTANT: Do not over-
tighten. Excessive force can
damage the couplings. Tighten by
hand; use a tool only in case of
a leak.
Turn on water supply (Fig 5C).
Flush out water lines before connecting the hoses to machine.
Installation/Removal
1. Unpack Washer/Dryer
Move the machine to its installation position. Remove the packing materials
carefully to avoid damage to the machine’s pre installed drain hose and power
cord. Make sure the machine is intact and report any damage to the retail
location you purchased your product from immediately.
WARNING: Destroy the carton and plastic bags after
unpacking washer-dryer. Plastic bags and other packing
material are not children’s toys and can be dangerous.
Built-In Installation
The Eurotech EWC177 can be
installed beneath a cabinet or
worktop with a height of 34-1/2“
( 876 mm). There must be a gap
of about 1/2“ (12 mm) all around
the machine, including between the
rear edge of the machine top panel
and the back wall. The opening
width must be at least 24-1/2“
(622 mm). Space must also be
available for the inlet and drain
hoses. See the diagram above for measurements and positions.
. Remove Shipping Bolts/Spacers/Grommets
The machines shipping security consists of shipping bolts (4), spacers and
grommets on the back panel to
secure the wash / dry drum during
shipping and delivery.
IMPORTANT: Remove all
shipping bolts/spacers/
grommets before using the
washer/dryer to allow
proper operation and
prevent damage to the
appliance.
Once the machine is in its
installation location, remove the
four locking 10mm bolts and plastic
spacers (Fig.1A). If plastic spacers
cannot be removed, open rear panel
(20 torx) screwdriver as shown in
Fig 1B, remove spacers and replace
the panel.
Keep bolts, shipping bolts, spacers
and grommets for future use.
Plug holes with four plastic plugs
enclosed packed with manual (Fig. 2)
Remove power cord restraints
before plugging in machine.
Installation Instructions

Fig. 1A
Fig. 1B
Fig. 2