Epson TOUCH DH200 - Manual (Page 35)

25
Using the Main Menu
2. Under ALARM SETUP, configure the
following:
• RECORD TIME: Set from 10~300 seconds (in
increments of 10 seconds).
• RECORD CAMERA: Select ALL or 1:1. If you
select ALL, the system will record on all
channels; if you select 1:1, the system will
only record for the designated channel
• ALARM BUZZER: Select ON/OFF . If ON, the
system will sound a beep when the external
alarm is triggered
• ALARM OUT1: Set the type of Alarm Out video
(external monitor required, not included).
Select SYSTEM, VIDEO LOSS, MOTION, ALL
ALARM, or ALARM IN1~8, and then select
ON/OFF.
3. Press ENTER to save your settings. Press
CANCEL/ESC to close remaining menu
windows.
NOTE: Alarm recording will take priority over
continuous recording, even if a camera is
disabled in standard recording parameters.
SCHEDULE
Set four recording modes in a daily
or weekly schedule.
NOTE: Daily has priority over a Weekly
schedule.
To set a recording schedule:
1. Press
WX
to select MODE1 (red), MODE2
(orange), MODE3 (green), or MODE4 (blue).
2. With a mode selected, configure the
following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. Audio channels vary
by model.
• MOTION: Select ON/OFF. Motion Grid and
sensitivity must be configured in the Motion
menu. See “MOTION” on page 23.
3. Select the CHART tab and select ALL,
SUN, MON, TUE, WED, THU, FRI, or SAT,
and press the ENTER button or +/-. The
Schedule sub-menu opens.
4. Enter BEGIN and END times, and select
the MODE for ten time slots.
Figure 16.1 Alarm Setup
TIP!
If an alarm is triggered on
the system, press the
Cancel/ESC button to
cancel the buzzer (if
enabled). Cancelling the
buzzer will not stop
recording.
Figure 17.0 Alarm Setup