Crivit Z31152 - Manual (Page 5)

4
INFLATABLE POOL
MODEL: Z31152
Repair Instructions
Retain these instructions for future reference. Special adhesive, which can be
obtained in any specialist shop, is required for these repairs. Only this special
adhesive should be used to carry out repairs as this is the only type which is suitable
for this pool. Repairs should only be carried out by adults.
Follow the special adhesive instructions carefully.
Additional information can be found here:
• Small punctures which are leaking air can be found by placing the surface of the
swimming pool under water. Air bubbles will indicate the area of the punctures.
• Mark these areas using a pen.
• Completely deflate the pool.
• Clean the area around the puncture to remove excess soap or dirt. Do not use
aggressive detergents as they could damage the surface of the swimming pool.
• Dry the affected area thoroughly before proceeding to the next step.
• Cut out a piece of the repair material provided. Ensure that it covers the
puncture with at least 2-3cm to spare on each side.
• Round off the corners.
• Trace the shape of the patch to be applied over the puncture onto the surface of
the pool if desired.
• Apply the adhesive onto the underside of the patch (some manufacturers
recommend applying adhesive onto both the patch and the damaged surface).
• Allow the adhesive to dry for the full length of time recommended in the
instructions.
• Place the patch over the damaged surface and press firmly.
• Place a weight on the patch while it is drying to keep it in place if desired and
allow to dry completely.
• When the repair is completely dry, apply extra adhesive onto the edges of the
patch to seal the patch and allow to dry completely.
Keep the patches and adhesive away from children. Avoid contact with eyes and
skin. Do not inhale or consume.