Crivit Paddling Pool - Manual (Page 11)

12 GB
Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it. Carefully read the
following operating instructions. Use the product
only as described and only for the given areas
of application. Keep these instructions safe.
When passing the product on to a third party,
always make sure that the documentation is
included.
Contents
1 x Paddling pool
2 x Screw-on-valve
1 x Set of instructions
Technical Data
Dimensions when inflated:
approx. 196 x 145 x 44cm
Weight: approx. 2.950g
Intended Use
Warning. For private outdoor use only.
Safety Instructions
Danger of Injury!
WARNING!
Danger of suffocation or children! Never allow
your children to play unsupervised with the
packaging materials or the article.
WARNING!
Never allow your children to play unsupervised
– Danger of drowning.
WARNING!
Children can drown in small quantities of water.
The pool must be emptied when not in use.
• Inflation and deflation should only be carried
out by adults.
• Check the article before every use for dama-
ge or wear. The article is should only be used
when in a flawless condition! Do not use the
article if you can see, or if you think, it might
be damaged.
• Do not use the product if it has begun to
deflate.
Prevention of damage!
• All inflatable articles are sensitive to cold
temperatures. The article should never be
folded or inflated at a temperature of under
15°C!
• In direct sunlight, the air pressure inside the
pool will increase and a danger of over-
inflation exists. Let a little air out if this starts to
happen.
• Make sure that the article – especially in its
inflated state – does not come into contact
with stones, gravel or sharp objects, and does
not drag or scrape against the ground. This
can cause damage to the outer pool surface.
• Only insert suitable pump adaptors into the
safety valves. Otherwise the valves could be
damaged.
• Do not over-inflate because this could burst
the seals. Close the valves tightly after infla-
ting.
• Avoid contact with sharp, hot, pointed or
dangerous objects.
• The paddling pool should not be placed on
concrete, asphalt or other hard surfaces.
Inflating
• Make sure that all of the air chambers are
completely inflated!
• Do not over-inflate the air chambers as this
could stretch the material or burst the seams.
• Use a standard air foot-pump or a double-
stroke piston pump to inflate the article, using
the correct valve adapter.