Electrolux CV 850 S/2 - Manual (Page 13)

26
Unscrew the top door holding pin and put it on the
other side.
Fit the door to the top door holding pin.
Fix the bottom door holders on the other side being
careful that the edge of the door is parallel with the
side of cupboard.
Then screw in the one screw in the place set free
on the other side as well as the adjustable feet (2
pieces) and set up the box.
Put over the handle and the plastic nails on the
other side.
Put the appliance to its place, set it level and apply
voltage to it.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
GB
Electrical connection
This refrigerator is designed to operate on a 230
V AC (~) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to
get an electrician to fit an earthed socket in
compliance with standards near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
– 73/23 EEC of 19.02.73 (Low Voltage Directive)
and subsequent modifications,
– 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.