Electrolux OHV - Manual (Page 38)

38 39
7.37 Remove and replace engine.
1) Remove belt cover ( Sections 7.31 & 7.32).
2) Remove both belts from engine pulleys. See
page 20
3) Tape idler Spring to outside of powerhead
body.
4) Remove traction drive belt idler bracket, belt
guide for auger drive, and engine pulleys.
5) Disconnect headlight wire harness on
engine.
6) Position Snowthrower with front of auger
down.
7) Remove Frame Bottom Pan (Section 7.42).
8) Remove Drive Plate Assy. (Section 7.43).
9) Place a piece of wood (15" long by 3/4"
thick) between Engine and Pivot Support.
10) Use a 1/2" socket with 15" extension to
remove the 4 engine mounting bolts.
11) Remove engine.
12) Place new engine on side on pivot support
for reinstallation. A board about 3/4" thick
placed across pivot support will help to position
engine while starting self-tapping screws.
Torque screws holding engine to chassis at
25-30 Ft.Lbs.
13) Reinstall Drive Plate Assembly,
(Section 7.45)
14) Place wheels back on axles so the blower
can be tipped back into operating position.
Reinstall engine pulleys, idler bracket with idler
pulley, belt guide, attach idler spring, and belts.
Adjust Belt Guide as shown in Section 6.01.
NOTE: With Frame Bottom Pan off, the belts
are accessible from the bottom for installation
on pulleys. Do not install bottom Pan until
belts are fully installed.
15) Reposition snow thrower with front of
auger down. Reinstall frame bottom pan.
Tip snowthrower back to operating position.
Reinstall belt cover.
WOOD SUPPORT
IDLER BRACKET
BELT GUIDE
ENGINE PULLEYS
DRIVE BELT
DRIVE SPRING
FRAME SLOT
FOR
DRIVE PLATE
BARREL
CONNECTOR
HOUSING
SCREW
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com