Florabest BT-1817 - Manual (Page 12)

14 GB
Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it. Carefully read the
following operating instructions.
Use the product only as described and only for
the given areas of application.
Keep these instructions safe. When passing the
product on to a third party, always make sure
that the documentation is included.
Scope of delivery/
Names of parts (figure A)
2 x Frame parts (1)
(with two holes and plastic plugs (1a) to
connect two flower stairs)
2 x Frame parts (2)
2 x Frame parts (3)
(with two holes and plastic plugs (3a) to
connect two flower stairs)
1 x Cross bar (4)
3 x Stair steps (5)
3 x Decorative elements (6)
18 x Screws (7) M6 x 25 mm
2 x Screws (8) M6 x 30 mm
9 x Screws (9) M6 x 12 mm
1 x Screw (10) M6 x 40 mm
1 x Nut (11)
1 x Ring spanner (12)
1 x Open-jaw wrench (13)
1 x Assembly instructions
Technical data
Dimensions: ca. 60 x 70 x 60cm (W x H x D)
Weight: ca. 8.75kg
Maximum load capacity per stair step: 25kg
Material: powder-coated metal
Colour: matt black
Correct use
This article serves to store e.g. plant pots and
decorative items. The article is designed for the
living area (balcony, terrace, and conservatory)
for private use.
Safety notes
Important! Read these assembly in-
structions through carefully and always
keep them for later use!
Danger to life!
• Never leave children unsupervised with the
packaging material. There is a risk of suffoca-
tion.
• The product is not a climbing frame or a toy!
Ensure that nobody, especially children,
stands on the product or pulls themselves up
on it. The product may tip over.
Risk of injury!
• Ensure that the article is properly stable
before use.
• Place the article on a level surface
• Be careful of your fingers when unfolding and
folding. Your fingers may be trapped and
cause injury.
• Ensure that the article is fully extended before
using it.
• Examine the article for damage or wear
before each use.
• The flower stairs has a maximum load capaci-
ty of 25kg per stair step.
Assembly
1. Remove the article from the packaging.
2. Attach the parts (1), (2), (3) hand-tight with
the screws (7), and part (4) with the screws
(8) (figures B and C).
Important: the holes for the stair steps
must face upwards!
3. Attach the three decorative elements (6)
under the three stair steps (5) with the screws
(9) (figure D).
4. Place the stair steps (5) on the article
and attach them with the screws (7)
(figures E - G).
5. Finally tighten all the screws firmly.
Fixing two flower stairs together
1. Remove the plastic plugs (1a)/(3a) from the
parts (1)/(3) that you wish to join (figure H).
2. Join the frame parts with the screw (10) and
the nut (11).