Epson RS830 - Manual (Page 14)

14
3. Place a 1-1/4" wide board (E) Fig. 22 against the front
of the table board (G), and a 5-3/4" wide board (J)
against the 1-1/4" wide board (E). Place the 1-3/4"
wide board (H) in the upright position against the
5-3/4" wide board (J). Tighten the knobs (D) until the
table boards are securely clamped.
Fig. 22
J
H
g E
1. Raise the track arm (A) Fig. 23 by turning the elevating handle (B) until you can attach the blade (C) on the motor shaft.
Tighten the arbor nut (D) using the supplied wrenches.
2. Place a framing square (E) Fig. 23 against the fence (H). Lower the track arm (A) Fig. 23 until the blade clears the table
surface.
3. Loosen the cuttinghead clamp knob (S) Fig. 24. Slide the cuttinghead (T) the entire length of track arm (A) to determine if
the blade (C) travels parallel to the square (E).
4. To adjust, loosen the index-ring locking screw (J) Fig. 25, and the track arm clamp handle (K).
5. Rotate the track arm (A) Fig. 24 until the blade (C) travels parallel to the square (E). Tighten the track arm clamp
handle (K) Fig. 26.
6. With the track arm clamp handle (K) Fig. 26 tightened, rotate the index ring (L) counter-clockwise until it stops. Tighten
the index ring locking screw (J) Fig. 27.
AdJUSTINg ANd CHECKINg
THE SAW BLAdE TRAVEL
7. Two miter index pointers are on this machine, one of
which is shown at (M) Fig. 27. To adjust, loosen the
screw (N) and move the pointer (M) until it aligns with
the “zero” mark on the miter scale (P). Tighten the
screw (N). Adjust the miter index pointer located on the
other side of column (R) in the same manner.
Fig. 23
Fig. 24
Fig. 25 Fig. 26
Fig. 27
H
E
C
d
A
B
S
T
C
E
A
L K
J
K
N
P
M
R
J
To reduce the risk of injury, turn unit off and
disconnect machine from power source before installing
and removing accessories, before adjusting or changing
set-ups or when making repairs. An accidental start-up
can cause injury.