Meradiso KR-1678 - Manual (Page 10)

10
Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it. Carefully read the
following instructions for use. Use the product
only as described and only for the given areas
of application. Keep these instructions safe.
When passing the product on to a third party,
always make sure that the documentation is
included.
Contents
1 x Inflatable travel bed
1 x Pump
1 x Storage bag
1 x Instructions for use
List of parts
(1) Cover
(2) Liner
(3) Zip fastener
(4) Valve
(5) Valve cap
(6) Diaphragm
(7) Air pump
(8) Pump hose
(9) Valve blue
technical data
Dimensions: approx. 151 x 63 x 19cm
Material: 100% polyester
Maximum load: 60kg
intended use
This travel bed has been developed as a leisure
article and is intended as a temporary bed for
children aged more than 3 years with a maxi-
mum weight of 60kg. This article is not a toy and
is not suitable for use on water!
Safety notices
Risk of injury
WaRning!
• Caution! Keep away from fire. Do not place
near a fire or other heat source such as radia-
tors, open hearths or hearths for electric fires.
• Danger of suffocation for children! Never let
children play unsupervised with the packag-
ing material or the article.
• Not suitable for children under 3 years!
The article contains small parts, which can
be swallowed.
• To avoid the danger of suffocation, the cover
and the storage bag must be kept out of the
reach of babies and children.
• This article is not a swimming aid and is NOT
suitable for use in water.
• The bed must be inflated and deflated only
by adults.
• The article must be used only under the super-
vision of an adult and must not be used as a
toy.
• Do not exceed the maximum permissible load
of 60kg. Exceeding the weight limit may
damage the product and make it unsuitable
for use.
• When it is in the sitting position, always sup-
port the article against a wall, otherwise it will
overbalance.
inflating the bed
Preparation
• Ensure that there are no toys or other objects in
the area in which you wish to place the bed.
• Unroll the bed and lay it out flat on the floor.
• Unzip the zip fastener (3).
• Insert the lining (2) into the cover (1) (Fig. A).
• note: Take care that the valve (4) of the liner
is located in the pillow end of the cover.
inflating the bed
• Connect the pump hose (8) with the blue
pump valve (9) (Fig. B).
• Open the valve cap (5) by turning it in an
anti-clockwise direction (Fig. C).
• Connect the pump hose with the valve and
inflate the mattress (Fig. D).
• Note: The valve is fitted with a recoil dia-
phragm (6). This opens automatically when
you begin inflating the bed.
• Important: Inflate the bed until it feels firm
and there are no longer any folds visible
in the material. Light pressure with the thumb
should slightly dent the mattress.
GB