Meradiso Z32169-BS - Manual (Page 5)

5 GB
Avoid the danger of death
from electric shock!
Before use, ensure that the mains voltage avail-
able is the same as the required operating volt-
age for the pump.
Before connecting the device to the mains you
should always check the device and the mains
lead for any damage.
A damaged device represents the danger of
death from electric shock.
Please consult a specialist electrician if you dis-
cover any damage or problems with the device,
or for the performance of repairs to the device.
Never open any of the electrical equipment or
insert any objects into it. Such interventions rep-
resent the danger of death from electric shock.
Never let the mains plug 5 and mains lead
come into contact with water or other liquids.
Never touch the mains plug with damp or wet
hands.
Do not use the mains lead for purposes for which
it was not intended.
Keep the mains lead away from heat, oil, sharp
edges or moving parts of the device. Damaged
or tangled mains leads increase the risk of
electric shock.
If the mains lead or mains plug of the pump is
damaged, the pump
2 must be scrapped! It
cannot be replaced!
Observe the regulations governing connections
to electrical power supply outlets applicable in
your country before connecting the device.
Contact an electrical specialist if you have any
questions.
Position the device and all electrical installations
and connections in a place that cannot be
flooded.
Do not use an extension power cords with this
product.
Always remove the mains plug from the socket
after pumping and deflating.
Do not operate the electric pump for more than
5 minutes at one time. Take a 30 minutes break
in between, as overheating may occur and pump
will automatically shut off. It will be ready to use
it has cooled down.
Do not obstruct the air passage opening or in-
sert any objects into the opening at any time.
Operation
Pumping up the air bed
Note: Before using the product for the first time,
check it carefully for holes, porous places and seams
that are not airtight.
Recommendation: Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
CAUTION! Inflatable plastic products react
sensitively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 °C and rises above 40 °C. Other-
wise damage to the product may result.
Note: Basically, only an adult should be responsi-
ble for pumping the airbed up. Make sure that you
do not pump too much air into the product. On no
account should you use a compressor. Stop the
process when resistance increases during pumping
and the seams start to stretch. Otherwise the mate-
rial might tear. Only use manual pumps and / or
pumps specifically designed for use with inflatable
plastic products.
Roll the product out and make sure the optional
air valve
3 is securely closed (see Fig. B / III).
Open the cover 4 on the pump 2 and take out
the mains lead and mains plug 5 (see Fig. C).
Insert the mains plug into the mains socket, and
turn the switch
6 to “inflate” (see Fig. D). After
approx. 3 ½ minutes the air bed 1 should be
fully inflated and ready for use.
Turn the switch to “OFF” to stop the process.
(see Fig. E).
Hold a ruler line at least 10 cm long up to the
measuring strip
8 . The rated pressure is reached
as soon as the measuring strip is 10 cm long
(see Fig. H). The ruler is not included with the
product.
If necessary, turn the switch to “deflate“ to let a
little air escape (see Fig. F).
43155_mer_Luftbett_Content_HU_SI_CZ_SK.indd 5 14.04.14 15:10