Topmove Luggage Rack A - Manual (Page 5)

7 GB
Assembly
1. Inserts (Fig. B)
Choose from the following options in accor-
dance with the diameter of your saddle post or
the handlebar stem:
• For a diameter of 24-26mm mount both
inserts (3) on the adapter (4) and the adapter
counter piece (1).
• For a diameter of 26-29mm mount one insert
on the adapter.
• For a diameter of 29-31mm do not mount any
inserts.
2. Mount the adapter on the handle-
bar or saddle post (Fig. C and D)
Fasten the adapter and the adapter counter
piece with 4 x screws, long (2), to the handlebar
or saddle post.
Tightening force: 4 newton metres
3. Adjust angle
Loosen the adjusting screw (4a) on the adapter
with the tool (11) (Fig. E), to adjust the angle of
the adapter (Fig. F). Next, re-tighten the adju-
sting screw (Fig. E).
Tightening force: 4 newton metres
4. Assemble and position adapter
fixture
Before assembling, make sure the
luggage rack (8) can be fastened to the
adapter with the short or the long side.
Decide which way you would like to
mount the product before assembling
the adapter fixture (6). Make sure that
the notch (6a) on the adapter fixture is
facing down (Fig. G).
Fasten the adapter and the adapter fixture
counter piece (7) with 3 x screws, short (5) in
the areas specified (Fig. H).
Tightening force: 4 newton metres
Do not fully tighten the screws yet.
You can still shift the adapter on the
braces of the luggage rack as required
(Fig. H).
After you have set the final position, tighten the
screws.
5. Connect the luggage rack with
the adapter (Fig. I)
Insert the adapter fixture (6) in the opening
provided on the adapter (4). Following this, test
whether the luggage rack is securely locked in
the adapter by pulling on it.
6. Assemble fastening strap (Fig. J)
Lay the ends of the strap (9d) around the lugga-
ge rack frame from above and pull the ends of
the strap with the edge from behind through the
strap-system slots (9c). Lower the strap ends (9d)
into the notches of the strap system.
Note: make sure that the logo (9b) is
facing upwards.
Hitch the strap grip (9a) onto the other end of
the frame.
7. Loading the product
a) Pull the strap grip (9a) from the luggage rack
frame (Fig. K).
b) Use the strap system (9c) to set the appropri-
ate strap length (Fig. L).
c) Load the product and pull the fastening strap
by pulling it over the load (Fig. M).
d) Fasten the strap grip (9a) to the frame so that
the load is fastened to the product (Fig. N).
8. Extra security with the expander
band
Set the length of the expander band (10) using
the buckle (10a). Fasten the load further with
the expander band by fastening the ends of the
expander band (10b) to the frame over the load
on the left and the right (Fig. O).
Lighting
No lighting is included with this article. You can
buy reflectors and back lights in specialist shops
that can be attached with a fastener.
These are mounted on the frame of the luggage
rack (Fig. P).
Remove article
Remove the load and press the unlocking button
(6b) in order to release the luggage rack from
the adapter (Fig. Q).