Melinera Z29617 - Manual (Page 42)

42 GB/MT
Starting up
 Changing the rechargeable battery
Note: You will need a crosshead screwdriver for this step.

First push the AUTO / OFF switch 11 to the OFF position.

Take the decorative attachment 1 off the rod with the LED
light bulb 3 .

Pull the rod with the LED light bulb 3 off the middle rod 6 .

Open the battery compartment 10 on the bottom of the solar
casing 5 . To do so, unscrew both screws using a crosshead
screwdriver .

Remove the used rechargeable battery 9 .

Insert a new rechargeable battery (NiMH, AA, 1.2 V /
600 mAh) into the battery compartment 10 .
Note: Ensure correct polarity. This is indicated in the battery
compartment
10 .

Close the battery compartment 10 . To do so, screw in both
screws using a crosshead screwdriver .

When you close the case 5 , make sure that the cables are
not pinched.

Place the rod with the LED light bulb 3 onto the middle rod 6
again.

Place the decorative attachment 1 back onto the LED light
bulb 2 .