Electrolux U28190 - Manual (Page 11)

11
7.Select the spin speed or Rinse
Hold Option
Press the “Spin” button repeatedly, in order to select
the desired spin speed or the Rinse Hold option.
The relevant LED will light up.
If you select the Rinse Hold option, the machine
will stop at the end of the programme with the water
still in the tub.
EWF 12108W
EWF 14108W
8.Select the desired option
Press the relevent button to select the required
options. Depending on the selected programm, only
certain options are available and shown during the
selection phase.
Note: Not all the options are compatible with
eachother. For the options that are not compatible,
the icons will disappear.
9.Select the Delay Button
Before you start the programme if you wish the
starting to be delayed, press the DELAY button. The
figures corresponding to the selected delay will be
displayed for about 3 seconds, after which the
duration of the selected programme will appear on
the display.
During this period it is possible to load other laundry:
• Press “Start” button;
• load the laundry;
• close the door and press “Start” button again.
10.Start the Programme
Press the “Start” button. The relevant LED will stop
flashing. and only the LED relevant to the phase that
is in progress will remain lit.
If you have chosen a delayed start, the washing
machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.
11.How to change a programme
during its cycle
You can alter the programme before it starts.
When the programme has started, you can only reset
it by turning the programme selector dial to «Off»
position and then you can select the new
programme. Start it by pressing the “Start” button.
12.How to interrupt a programme
during its cycle
Press the “Start” button to interrupt a programme
which is running, the corresponding LED starts to
flash. Press the same button again to restart the
programme .
New_12108_14108.qxp 12/12/2005 5:41 PM Page 11