Elta LE100 User Manual
Page 4
INSTRUCTION MANUAL
LE100 AIR DEHUMIDIFIER
Dear customer,
Please read these Operating Instructions through carefully before connecting your device to
the mains, in order to avoid damage due to incorrect use. Please pay particular attention to the
safety information. If you pass the device on to a third party, these Operating Instructions must
also be handed over.
CONFIGURATION
1. Control lamp
2. Control lamp
3. Regulator
HUMIDISTAT OFF/MAX
4. Switch /
5. Air intake
6. Water tank
7. Level indicator
8. Line cord with power plug
9. Water disposal opening
10. Air exhaust
SAFETY TIPS
• Wrong operation and improper handling can cause problems with the appliance and injury to
the user.
• The unit may be used only for the intended purposes. No liability is accepted for damages
arising from improper use or faulty handling.
• Before connecting to the mains, please check whether the type of supply and the mains
voltage match with the details given on the nameplate on the inner unit.
• Do not immerse the appliances and mains plug in water or other fluids. Should the appliance
still fall in water some time, pull out the power plug immediately and have the appliance
checked by an expert before using it again. There is danger to life from electrical shock!
• Do not try to open the appliance casing yourself!
• Do not introduce any kind of objects into the appliance casing.
• Do not use the appliances with wet hands, on moist floor or when the ambience is humid.
• Do not hold the mains plug with wet or moist hands.
• Check the mains plug and mains adapter regularly for damages. In case of damages, have
the power cord and mains plug changed by the manufacturer, or a qualified expert, in order
to avoid danger.
• Do not operate the appliance, if power cable or the mains plug shows damage or the unit
falls to the floor or has been damaged otherwise. In such cases, bring the unit to the
workshop for checking and repairs, if necessary.
• Do not ever try to repair the appliance yourselves. There is danger from electrical shock!
• Do not let the power cord hang over sharp edges and keep it away from hot objects and
open flames. Pull the plug itself to remove it from the plug socket.
• Installation of a leakage current protector unit will offer additional protection with a nominal
release current of not more than 30 mA in the house installation. Please consult your
installing electrician.
• The cable as well any extension cable required should be laid such that there will not be any
risk of anyone tugging on it inadvertently or tripping over it.
• If an extension cable is used, it must be suitable for the power, otherwise it can cause
overheating of the cable and/ or the plug.
• This appliance is suitable neither for commercial use nor for use outdoors.
• Do not let the unit run unsupervised, while it is operating.
•
Switch the appliance off before disconnecting from the mains.
• Caution! The appliance is on power so long as it is connected to the power circuit.
SPECIAL SAFETY INSTRUCTIONS
• Caution! Do not operate the dehumidifier at temperatures lower than 5 °C in order to avoid
the ice formation in the interior of the device.
• Keep a free space of 10 cm around the device.
• Doors and windows should be closed while the device is running in order to use the device
at the highest level.
• Always operate the device in upright position.
• Let the device in upright position after transport or when it has been inclined (e. g. during
cleaning) for at least an hour before you connect it to the power supply system.
• Always keep the air intakes and the air exhausts (5, 10) clean.
• Connect and disconnect the device by means of the regulator HUMIDISTAT OFF/MAX (3)
only, never connect it by means of the power plug.
• Before moving it, disconnect the device, pull out the power plug and empty the water tank.
• Never squirt sprays or other flammable cleaning agents on the device.
BEFORE OPENING
• Remove all packing materials.
• Clean the device as described in
Cleaning and care.
• When you must use the provided active carbon filter
remove the water tank (6) with the grip underside the
water tank from the device. Then pull the filter
downwards (see figure).
• Detach the filter retainer from the filter and insert the
active carbon filter. Reinsert the filter retainer and make sure that all retaining collars hold the
filter retainer.
• Push the filter upwards in the device until it locks in place. Reinsert the water tank (6).
5
6
GB
GB
GB
GB
1 2 3
4
5
6
8
9
10
7
➡
Filter retainer
Filter
Active carbon filter
Filter
/
ÃÊ>««>ViКГКМКМi`i`ÊvÀÊÕÃiÊLÞÊV
`АiКАКМ
iАК«iАГГКЬМ
ХМ
>ГГГМ>ViКАКГХ«iАЫГКvКМ
iАК«
ЮГV>]КГiГАЮКАКiÌ>ÊV>«>LÌiÃÊ«ÀiÛiÌÊÌ
iКvА
ХГ}КМКГ>viЮ°К
`АiКГ
Х`ÊLiÊÃÕ«iÀÛГi`КМКiÃÕÀiÊÌ
>ÌÊÌ
iЮК`КМК«>ЮКЬМ
КМ
iК>««>Vi°К