Miomare LED Washbasin Fitting / LED Bath/Shower Fitting - Manual (Page 9)

9 GB/IE
Operation / Maintenance and Cleaning
Note: when starting the fitting for the first time the
LEDs will first flash blue, green and red before indi-
cating the temperature based on the temperature
(self-test).
Note: If the tap has not been used for a long pe-
riod, flush the pipes thoroughly to avoid stagnation
and build-up of residue.
Open the main water supply.
Lift the handle
23 and swing it to the right or
left in order to regulate the speed or tempera-
ture of the water.
Hot water:
Swing the handle
23 to the left.
Cold water:
Swing the handle
23 to the right.
Maintenance and Cleaning
Maintaining and
cleaning the tap
Please note that sanitary taps require special care
and attention. Therefore, please follow the instructions:
When cleaning, never use petrol, solvents,
aggressive cleansers or hard cleaning brushes
etc. These could damage the surface of the
product.
Dry your fitting with a cloth after every use to
prevent any lime deposits.
Clean the product with a damp, soft cloth and
a mild cleaning agent if required.
Non-observance of the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the guarantee.
Replacing the LED insert
If the LED lamps fail to light, the LED insert may be
replaced.
LED life: approx. 10,000 operating hours.
A new LED insert (ET-WCRL-LED) can be obtained
from the specified service address.
To do so, follow these steps:
Unscrew the fitting mixer 1 from the fitting
body (see Fig. D1), which requires a cross-tip
screwdriver.
Unscrew the LED cover from the fitting body
using the socket head wrench 21 (see Fig. D2).
Remove the plastic LED insert (see Fig. D3–D4)
using the LED installation wrench 22 .
Install the new LED insert, the LED cover and
the fitting mixer 1 similar to disassembly (see
Fig. D5-D7).
Replacing the screen
If the screen inside the LED cover is severely clogged
it must be cleaned or replaced.
To do so, follow these steps:
Unscrew the fitting mixer 1 from the fitting
body (see Fig. D1), which requires a cross-tip
screwdriver.
Unscrew the LED cover from the fitting body
using the socket head wrench 21 (see Fig. D2).
Push the screen out of the LED cover from the
outside, using a flat object (see Fig. E1).
CAUTION RISK OF INJURY! The outer
edge of the screen fabric may be pointy.
Remove any limescale deposits or foreign bodies.
Replace the screen if severely clogged or dam-
aged. A new screen (ET-WCRL-WTS) can be
obtained from the specified service address.
Press the cleaned / new screen into the LED cover
from the inside (see Fig. E2).
Note: be sure the screen is properly seated in
the LED cover.
Install the LED cover and the fitting mixer 1
similar to disassembly (see Fig. D6-D7).
Replacing the cartridge
A cartridge 28 is a wear part that needs replacing
according to the hardness and / or degree of