Miomare Sink Mixer Tap / Kitchen Mixer Tap / Bath and Shower Mixer Tap - Manual (Page 31)

31 GB
Introduction / Safety information / Installation
1 Socket head wrench 21
1 Instructions for assembly/operation
Safety information
DANGER TO
LIFE AND RISK OF ACCIDENTS
FOR INFANTS AND CHILDREN!
Never leave children unattended with the pack-
aging material. Suffocation hazard. Keep this
product well away from children. This product
is not a toy.
BEWARE OF ELECTRIC SHOCK!
Leaking or water discharge can
lead to life-threatening danger due
to electric shock. Carefully check that all con-
nections are watertight. Also ensure that all
wires of electric appliances are correct and
have been securely installed.
CAUTION! RISK OF INJURY! Please ensure
that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could lead to injury. Please note that washers
and gaskets are wear parts and therefore will
need to be replaced from time to time. Dam-
aged parts could impact safety and function.
Be sure all seals are correctly seated.
SCALDING RISK! Should the scald protec-
tion be defective or not activated, hot water
can lead to scalding. Therefore activate the
scald protection as is described in Chapter
„Scald protection“ and check the settings very
carefully.
CAUTION! Be careful not to reverse the hot/
cold water plaque 24 . The correct position is:
left = red (hot water),
right = blue (cold water).
CAUTION! DAMAGE TO THE ARTICLE!
Please have all installations performed by
skilled individuals.
Please note that the seals are wear parts and
must be changed from time to time.
Any leakage or sudden escape of water can
cause considerable damage to buildings and
property. All connections must therefore be
checked carefully to ensure that they are tight.
Familiarise yourself prior to installation with all
local conditions, e.g. water connections and
shut-off device.
The product is only suitable for use in rooms in
which a temperature above 0 is maintained.
Installation
Note: Familiarise yourself with the product prior to
assembly. Carefully read the following assembly in-
structions and safety advice. In the event of incor-
rect installation, all warranty claims – particularly
in relation to subsequent damage – are excluded.
CAUTION! Before you start installation turn
off the water supply at the mains. Otherwise
injuries and/or property damage may occur.
CAUTION! Do not twist the connection
hoses
10 or place them under tension.
Please note: this step requires a cross-tip
screwdriver, a slotted screwdriver and an
open-ended spanner SW 12 mm.
Follow these steps:
Place the fitting base seal 2 inside the groove
on the base of the fitting 1 .
Screw the two flexible connection hoses 10
hand tight into the designated female threads
of the fitting
1 (see Fig. B).
Note: The two flexible connection hoses 10
are identical.
The flexible connection hose
10 being screwed
into the left borehole on the fitting body will be
the hot water hose, the flexible connection
hose
10 being screwed into the right borehole
will be the cold water hose.
CAUTION! Be sure to only tighten the flexible
connection hoses 10 hand tight (see Fig. B).
Do not use pliers or a wrench. Otherwise the
product could be damaged.
Remove the locknut 9 from the threaded
bolt 8 and using a screwdriver, screw the
threaded bolt 8 all the way into the desig-
nated female threads at the bottom of the
fitting
1 .
Insert the pop-up pull rod (part 1) 3 into the
back opening of the fitting.