Euro-Pro ULTRA SHARK EP366 - Manual (Page 5)

ASSEMBLY
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
HAND VACUUM WILL
NOT OPERATE
1. Power cord not firmly
plugged into outlet.
2. No power in wall outlet.
3. Needs
servicing.
1. Plug unit in firmly.
2. Check fuse or breaker.
Replace fuse/reset
breaker.
3. Call 1 (800) 798-7398.
HAND VACUUM WILL
NOT PICK-UP OR
SUCTION POWER IS
WEAK 1. Dust cup filter is full.
2. Unit
clogged.
3. Dust cup filter needs
cleaning.
1. Empty dust cup filter –
(see page 4).
2. Turn unit off and unplug
from wall outlet. Remove
dust cup filter and check
for object(s) in air duct
and remove.
3. Clean or replace dust cup
filter. (see page 4).
DUST ESCAPING
FROM HAND
VACUUM
1. Dust cup filter is full.
2. Dust cup filter is not
installed correctly.
3. Puncture/hole in dust cup
filter.
1. Empty dust cup filter.
2. Review dust cup filter
instructions. (see page 4)
3. Replace dust cup filter.
(see page 4)
HAND VACUUM HOSE
OR BRUSHES WILL
NOT PICK-UP
1. Hose clogged.
2. Dust cup filter is full.
1. Remove hose and/or
bushes. Remove
obstruction from hose.
2. Empty and clean dust cup
filter.
1. To open the dust cup (container) (10), push button (1) and pull out the dust cup (10).
Verify that the dust cup filter (8) is inside, then attach the dust cup (container) (10)
to the hand vacuum.
2. To use the Hand Vacuum with the shoulder strap (5), attach it to the unit as shown below.
Note: Dust cup filter (8) must be used when operating the hand vacuum.
Warning: Always unplug from electrical outlet before opening the dust cup (container) (10).
3. To attach the cleaning brush (6) or crevice brush (7) to the Hand Vacuum, push brush
into the suction hole (3), as shown below.
4. To use the flexible hose (11), push the end of the hose into the suction hole (3), then
attach the desired brush (6 or 7) to the other end of the flexible hose (11), as shown
below.
3 6