Edimax Technology AR-6024WG - Manual (Page 18)

preset amount of time. The default is 60 seconds. If you set the time to 0, the
ISDN connection will remain always connected to the ISP.
Keep Alive: If mode is LCP, This is the Keep Alive timer. If a reply to the LCP echo is
not received in this amount if time, the connection is dropped. The Default is 10.
Authentication: Set the required authentication protocol. (Auto/ CHAP/ PAP)
MRU: Maximum Receive Unit indicates the peer of PPP connection the maximum size
of the PPP information field this device can be received. The default value is 1492
and is used in the beginning of the PPP negotiation. In the normal negotiation, the
peer will accept this MRU and will not send packet with information field larger
than this value.
PVC Settings
VPI: If instructed to change this, type in the VPI value for the initial connection (using
PVC 0). Default = 0.
VCI: If instructed to change this, type in the VCI value for the initial connection (using
PVC 0). Default = 0.
QoS: Quality of Service type. Select CBR (Continuous Bit Rate) to specify fixed
(always-on) bandwidth for voice or data traffic. Select UBR (Unspecified Bit Rate)
for applications that are non-time sensitive, such as e-mail. Select VBR (Variable
Bit Rate) for burst traffic and bandwidth sharing with other applications.
PCR: Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak
Cell Rate (PCR). This is the maximum rate at which the sender can send cells.
SCR: The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted.
Name: Enter the name of your ISP. This information is for identification purposes only.
17