Rocktrail 12V Electric Cool Box - Manual (Page 19)

19 GB/MT
Safety while operating
the appliance
Before putting the appliance into operation, en-
sure that the connection cable and plug are dry.
CAUTION! RISK OF FIRE! Never place the
appliance in direct proximity to naked flames
or other sources of heat.
ATTENTION! RISK OF OVERHEATING!
Ensure that the ventilation slits on the top of the
electrical lid of the appliance are not covered,
and that the heat, which arises during operation,
can be dissipated adequately. Ensure that the
appliance is situated at an adequate distance
(approx. 30 cm) from walls or objects, so that
the air can circulate freely.
This appliance must not be exposed to rain.
Do not fill any liquids or place any ice directly
into the inside of the appliance. If you do, this
could result in damage to the product.
Never immerse the appliance in water. If you
do, this could result in damage to the electrics.
When travelling by vehicle, do not transport
the appliance in the passenger compartment.
When operating the appliance, always ensure
that the 12 V plug is located firmly and safely
in the connection socket of the cigarette lighter,
and that the connection socket is free of dirt. If
the contact between the plug and socket is in-
adequate, vibration from the vehicle can cause
the power supply to switch on and off in short
bursts. This can result in overheating.
The manufacturer has no liability for damage
which is caused by improper use or incorrect
operation.
Do not store in this appliance any materials, which
are potentially explosive, such as for example
aerosol cans with inflammable propellant gas.
General information on use
The coolbox is not suitable for continuous oper-
ation. Ice can form on the aluminium cooling
plate. We recommend that the coolbox is switched
off after it has been in operation for 6 days.
The coolbox can be put back into operation after
2 hours.
Dry the surfaces of your coolbox contents, so
that a build-up of condensation is avoided.
If the coolbox is not being used, keep the con-
nection cable in the storage compartment pro-
vided in the electrical lid of the coolbox.
Be careful not to switch the vehicle engine on
and off frequently, so that the power supply to
the coolbox is not interrupted constantly. Also
be aware that the vehicle battery can be run
down too far, if the engine is switched off.
The recess in the inside of the electrical lid can
be used to store a standard 1.5 l bottle with a
standing height of max. 36.5 cm.
Operation
Before putting the coolbox into operation, we rec-
ommend for reasons of hygiene that it is washed in-
side and outside with a damp cloth (see also
chapter on „Cleaning and care“). Moreover don‘t
keep any unpackaged food in it.
Place the coolbox on a firm and level surface.
The connection cable is permanently connected
to the coolbox and can be found in the cable
compartment in the right, rear side of the appli-
ance.
Connect the 12 V connection cable to the socket.
The coolbox starts to work immediately.
Fastening the electrical lid by
means of the carrying handle
Fold the carrying handle 1 forwards to close
the electrical lid 2 tightly (see figure B1).
Fold the carrying handle 1 vertically while
the coolbox is being transported. The electrical
lid
2 is tightly closed (see figure B2).
Fold the carrying handle backwards to be able
to open the electrical lid 2 , (see figure B3).