Rocktrail BG 2010 - Manual (Page 2)

Löt- und Gasgeräte GmbH
Bahnhofstraße 50, D-74254 Offenau
Tel. +49 7136 9594-0
Fax +49 7136 9594-44
Internet: www.cfh-gmbh.de
E-Mail: [email protected]
S
tand: VO-12.12
performance (big flame). By turning the gas regulation valve in direction
(-) the gas flow decreases (small flame).
Steps to be taken before attaching the butane gas cartridge
Only change cartridge when outside and far away from other persons.
After each attachment or a change of a cartridge you must carry out a
test for leaks (see Test for Leaks). Make sure that all attachments and
other connections are correctly connected and nothing is damaged.
Ensure that parts where the gas flows are not damaged. Never use a
damaged device. Before attaching the butane cartridge, close the gas
regulation valve on the device (see picture 4 / (-) switch off gas supply).
Before attaching each new gas receptacle check the gasket (visual check
– picture 5). It is necessary to ensure that at the upper part of the
stove inside on the piercing pin there is a black rubber gasket, and
that this gasket is in a good condition (see drawing - picture 5). If
this gasket is missing or is damaged do not use the device. The
replacement gasket can be changed only by an authorized specialist
dealer or the manufacturer. Do not make any alterations to the
device! Make sure, always before you light the flame on the burner that
all parts are gastightly connected.
Attaching the butane cartridge
When assemblying the device hold it upright (burner pointing upwards
and the bottom of the lower part of the camping stove – cartridge holder
- pointing downwards). Screw all parts together precisely and without
interruption. Do not strip the screw thread.
Close the regulation valve on the upper part of the device by turning it
clockwise (-) (see drawing - picture 4). Place the butane gas cartridge
into the cartridge holder (see drawing - picture 2). Now screw the cartridge
holder gastightly to the upper part (see picture 3), till the latch at the side
snaps (see picture 5).
Changing the butane cartridge
It is possible to change the butane cartridge only if it is completely empty
(see section headed Security instructions – Warning). Check that the
cartridge is empty before changing (shake it a little if splashing of liquid
is audible). Make sure the flame on the burner is extinguished before
loosening the cartridge. You can loosen the lower part from the upper
part by pressing the security latch at the side (see picture 5) and rotating
the lower part counterclockwise (picture 1). Take the empty butane
cartridge from the lower part of the device and dispose of it accordingly.
Now you can attach a new butane cartridge (see Steps by attaching the
butane cartridge).
How to operate the device
After properly fitting of the butane cartridge and testing for leaks (to be
carried out outside), turn now the gas regulation valve by about a half
rotation counterclockwise towards (+). Light the flame on the burner tip
with a match or a lighter and only now turn on completely the gas
regulation valve, so that the flame can reach its highest performance.
Do not shake the device immediately before lighting the burner and after
having lit it do not move it any more. Otherwise there is a danger that
the liquid gas will leak and an uncontrolled flame will ignite. Place the
device on an even surface protected from wind. Wind could extinguish
the flame and the gas could further escape from the device – danger
of injury or burn. In a case the flame extinguishes uncontrolled (e.g.
wind blast) immediately turn off the gas regulation valve (see picture 4
/ (-) = switch off gas supply) and restart the device again as described
above. Use the device only in an upright position and under a permanent
supervision of adult persons.
Switching off the device
By turning the gas regulation valve clockwise to the right (-) (see picture
4) the supply of gas is stopped and the flame extinguishes. Have in mind
that the burner is still very hot and that it must cool down before it is
stored.
Storage and transport
Follow the safety instrauctions stated on the butane cartridge.
Storage: Store the device in a vertical position!. Never store the device
or the butane cartridges below ground level (e.g. cellar, boiler room).
Storing area must be sufficiently ventilated.
Transport: Ensure that the device stands securely upright and it must
not fall over or fall down. Always secure the device during the transport.
Care of the device + Repair service
It is allowed to use only recommended spare parts. Do not use a device
where any parts are damaged. Any repairs as well as replacement of
the nozzle can be carried out only by an authorized specialist dealer for
liquid gas or by the manufacturer. In case of a repair contact the
manufacturer at the maintenance address below. The nozzle is marked
with 22 (nozzle No. 22 – corresponds with the nozzle diameter of 0,22
mm). Do not make any modifications to the device.
Changing the gasket
When changing the gasket the wider lower rim of the new gasket must
fit precisely to the gasket holder on the piercing pin. The rubber gasket
can be replaced only by an authorized specialist dealer or by the
manufacturer.
Warranty
The warranty for this device is 3 years from the date of purchase. The
warranty starts with the date of purchase. Please keep the original receipt
in a safe place. This document is required as a proof of purchase. If any
material or manufacturing defects occur within 3 years from the date of
purchase of this product, the product will be either repaired or replaced
free of charge for you - at our discretion. This guarantee presumes that
you submit the defective device and the proof of purchase (receipt)
together with a short description of the defect and when the defect
occurred within 3 years. In case that the defect is covered by our warranty,
you will receive either the repaired product or a new one. In case of a
warranty claim, please contact us by E-Mail under [email protected].
We will contact you immediately.
Cleaning the device
It is possible to clean the device with a dry cloth only when the burner
has cooled down. Do not use any cleansing agents because the openings
in the burner and the nozzle could become blocked.
Environmental instructions
The gas used is environment-friendly liquid gas, which does not burden
or damage the environment and it is not dangerous for the ozone layer.
The butane cartridge or its contents do not have a restricted shelf-life.
Follow the regulations for the liquid gas.
Disposal of the butane cartridge
Totally emptied butane cartridges must be disposed of by using the
Dual recycling system. Butane cartridges, which are not completely
empty have to be disposed of at collection centres for harmful substances.
Disposal of the device
The device is produced of recyclable materials. To dispose of or to
recycle this device, get in touch with an authorized local Recycling Office
or a waste disposal company.
Technical data
Gas type: butane, unregulated, in a pressure gas
cartridge
Related heat input: appx. 70 g/h
appx. 0,97 kW
Nozzle No. 22
Nozzle: Ø 0,22 mm
Device category: vapor pressure butane (I
3
)
Burning time with 1 butane cartridge approximately 2,5
hours
The performance in the operating manual applies to measurement results
with test gas under test conditions. When using the provided butane
cartridge under normal conditions, deviations in the related heat input
can occur. (Important information: The ambient temperature has an
essential influence on the performance of the device. As a general
rule is that the performance decreases at low temperatures).
We wish you much pleasure with your Camping Stove.
Technical and optical parameters subject to change
Status: 12/2012
Maintenance address and manufacturer: