Tronic H12276 - Manual (Page 9)

9 GB/IE
Q
Operating instructions
Q
Measuring D, C, AA and AAA battery
j Place a battery of the type D, C, AA or AAA in the battery tester (see fig. A).
Note: In doing so, please observe the correct polarity. This is shown on the battery tester.
Note: Please ensure for proper contact between the battery and the battery tester.
j Secure the battery by means of the extendable contact arm 1 (see fig. A).
j Read the voltage of the connected battery using the voltage display 5 and the 1.5 V scale 4 .
Q
Measuring 9 V battery
j Position the 9 V battery on the test contacts 7 (see fig. B).
Note: In doing so, please observe the correct polarity. This is shown on the test contacts 7 .
Note: Please ensure for proper contact between the battery and the test contacts 7 .
j Read the voltage of the connected battery using the voltage display 5 and the 9 V scale 6 .
Q
Troubleshooting
= Fault
= Cause
= Solution
Battery tester does not react.
Electrostatic discharge can affect the function of the battery tester.
Press the reset button 2 on the back of the battery tester. For this purpose a paper clip or a
similar object can be used.
The battery to be tested has been inserted incorrectly.
Insert the battery to be tested according to the correct polarity.
The resulting measurement is unlikely.
The battery has not been inserted properly.
Remove the battery and wait for a few seconds, or press the reset button 2 . Reinsert the battery.
Q
Cleaning and maintenance
j The device should only be cleaned on the outside with a soft dry cloth.
j Under no circumstances should you use liquids or detergents, as these will damage the device.