Ericsson LBI-39169 - Manual (Page 39)

CONFIGURING EDACS DEVICES LBI-39169
39
Figure 20 - Console User Profile Configuration Example Screen
9.2 TELNET SESSIONS TO THE PI, BCU, CAL, AND EDG
Telnet access into each device is password-protected. Therefore, the user requesting access must have login privileges
for the remote device. The normal Telnet capability of the HP workstation provides VT100 emulation, which is the normal,
generic emulation for simple applications. Generic VT100 emulation is used for the PI, BCU, CAL, and EDG for Telnet
connections. This level of terminal emulation is bundled with HP-UX.
1. On the Switch Center submap, highlight the device’s icon.
2. From the Main Menu bar, select the EDACS -> Configuration -> Connect -> Telnet(xterm) menu item.
3. Enter the your username and password to gain access to the device. Refer to the device’s User manual for additional
information.
9.3 TELNETING TO THE SYSTEM MANAGER
Telneting to the System Manager uses VT220 emulation because it is a VAX/VMS system running a screen-oriented
application. From the Network Manager, invoke the System Manager program using the following procedure:
1. On the Switch Center submap, highlight the System Manager icon.
2. From the Main Menu bar, select the EDACS -> Configuration -> Connect -> Telnet (VT420) menu item.
The Network Manager will display the System Manager log on screen as shown in Figure 21.
3. Enter the Username (default Username is “EGESYSMGR”) and press the <Enter> key.
4. Enter the Password (default Password is “EGESYSMGR”) and press the <Enter> key.