Fig 1 fig 2, Preparing wrench for use 4. operating instructions – Sealey SA291 User Manual
Page 2
WARNING! Ensure you read, understand and apply safety instructions before use.
4.1. Only use impact sockets which are specifically designed for use with a impact wrench.
4.2. Connect the wrench to the air hose as in Section 3.
4.3. Place the socket over the subject fixing and depress the trigger to operate the wrench.
4.4. To change wrench direction, rotate the control nut left or right.
4.5. The air flow is also regulated by turning the control nut.
DO NOT use any additional force upon the wrench in order to remove a fixing.
DO NOT allow wrench to free run for an extended period of time as this will shorten its life.
3.1. Air Supply
Recommended hook-up procedure is shown in fig 1.
3.1.1. Ensure wrench air valve (or trigger) is in the "off" position before connecting to the air supply.
3.1.2. You will require an air pressure of 90psi and an air flow according to specification.
3.1.3.
WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the
wrench. Too high an air pressure and unclean air will shorten the product life due to excessive
wear and may be dangerous, causing damage and/or personal injury.
3.1.4. Drain the air tank daily. Water in the air line will damage the wrench.
3.1.5. Clean air inlet filter weekly.
3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/2” I.D. and fittings must have the same
inside dimensions.
3.1.7. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain
that all connections are secure.
3.2. Couplings.
Vibration may cause failure if a quick change coupling is connected directly to the wrench. To
overcome this, connect a leader hose to the wrench. A quick change coupling may then be used to
connect the leader hose to the air line recoil hose. See fig 1 & 2.
3.
PREPARING WRENCH FOR USE
4. OPERATING INSTRUCTIONS
Fig 1
Fig 2
Control nut
Trigger
Original Language Version
SA291.V3 Issue: 5(SP)- 12/11/13
© Jack Sealey Limited