Exmark Mower Pioneer E-Series 4500-996 Rev A - Manual (Page 39)

Maintenance
Figure 30
1. Nut 4. Control plate
2. Turnbuckle 5. Return to neutral plate
3. Stationary plate 6. Tabs touching return to
neutral plate
8. Tighten nuts.
9. Shut off unit. Remove jumper wire from wire
harness and plug connector into seat switch.
10. Remove the jack stands.
11. Raise the deck and re-install the height of cut pin.
12. Check that the machine does not creep in neutral
with the park brake disengaged.
Adjusting the Seat Ride
Suspension
The number of seat springs can be changed to
maximize rider comfort. More springs should be used
with heavier operators and on rough terrain. Fewer
springs should be used with lighter operators and
when mowing smooth, well established lawns. Always
keep the number of springs on the left and right side
the same when adding and removing springs.
Figure 31
1. Bolt 3. Nut
2. Spring 4. Additional mounting
holes
Up to five springs can be secured to the seat box with
a nut and bolt, see Figure 31.
Refer to the Parts Manual for spring and hardware
part numbers.
Electric Clutch Adjustment
No adjustment necessary.
39