Sealey SA604 - Manual

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
p
WARNING! Ensure health & safety, local authority, and general workshop practice regulations
are adhered to when using this equipment.
p
WARNING! Disconnect from air supply before changing accessories or servicing.
3 Maintain the wrench in good condition and replace any damaged or worn parts. Use genuine
parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
p
WARNING! Check correct air pressure is maintained and not exceeded. We recommend 90psi.
3
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each
use and ensure that all connections are secure.
3
Wear approved safety eye/face shield, ear defenders, and hand protection.
p WARNING! Due to the possible presence of asbestos dust from brake linings, when working
around vehicle brake systems we recommend you wear suitable respiratory protection
3
Only use impact sockets which are specifically designed for use with an impact wrench.
3
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
3
Keep children and non essential persons away from the working area.
7
DO NOT use the wrench for a task it is not designed to perform.
p WARNING! DO NOT use wrench if damaged or thought to be faulty (contact Service Agent).
7
DO NOT use wrench unless you have been instructed in its use by a qualified person.
7
DO NOT carry the wrench by the air hose, or yank the hose from the air supply.
7
DO NOT operate wrench if you are tired, under the influence of alcohol, drugs or intoxicating
medication.
7
DO NOT carry wrench with your hand on the power trigger in order to avoid unintentional
starting.
7
DO NOT direct air from the air hose at yourself or others.
3
When not in use disconnect from air supply and store in a safe, dry, childproof location.
INSTRUCTIONS FOR:
3/4” AIR IMPACT WRENCH
MODEL No:
SA604
2. INTRODUCTION & SPECIFICATIONS
Twin hammer mechanism utilises oversized hammers and specially strengthened hammer cage to
pull even more torque out of the precision air motor. Precision made components fit closely to
reduce air leakage and maximise power. Flip reverse control on the rear of the tool with 4-position
air regulator on the handle base. Suitable for heavy tyre shop use.
Original Language Version
SA604 Issue:6(SP)-24/07/13
Drive size:. . . . . . . . . . . . . . . . . 3/4”
Working/Max torque: . 950/1150ft/lb
Ultimate torque: . . . . . . . . 1200 ft/lb
Speed: . . . . . . . . . . . . . . . 6500rpm
Air consumption:. . . . . . . . . . 5.6cfm
Operating pressure: . . . . . . . . 90psi
Air inlet size:. . . . . . . . . . . 1/4” BSP
Weight: . . . . . . . . . . . . . . . . . . 4.6kg
Noise Power: . . . . . . . . . . 108dB(A)
Noise Pressure: . . . . . . . . . 97dB(A)
Vibration: . . . . . . . . . . . . . .10.3m/s²
Uncertainty Value: . . . . . . .1.51m/s²
© Jack Sealey Limited