Sealey SA800 User Manual
Safety instructions
INSTRUCTIONS FOR:
AIR PALM ORBITAL SANDER 150MM
(DUST-FREE - SA801.V5)
MODEL No’s:
SA800.V5, SA801.V5
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations
are adhered to when using this equipment.
WARNING! Disconnect from air supply (and dust-free system if connected) before changing
accessories, servicing or carrying out maintenance.
Maintain the
sander in good condition (use an authorised service agent).
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
Use the sander in a suitable work area and keep area clean, tidy and free from unrelated
materials. Ensure that there is adequate lighting.
Before each use check abrasive disc for condition. If worn or damaged replace immediately.
WARNING! Always wear approved eye or face protection when operating the sander.
If dust is generated, use face, dust or respiratory protection in accordance with COSHH
regulations.
Depending on the task, sander noise level may exceed 85dB, in which case wear safety ear
defenders.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain
and/or tie back long hair.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Keep children and unauthorised persons away from the working area.
Ensure the workpiece is correctly secured before operating the sander. Never hold workpiece
by hand.
Check the workpiece to ensure there are no protruding nails, screws, stones, etc.
Avoid unintentional starting.
WARNING! Ensure that the correct air pressure is maintained and not exceeded.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use
and ensure that all connections are secure.
Prolonged exposure to vibration from these tools poses a health risk. It is the owner’s
responsibility to correctly assess the potential hazard, issue guidelines for safe periods of use
and offer suitable protective equipment.
DO NOT use the sander for a task it is not designed to perform.
DO NOT operate sander if any parts are damaged or missing as this may cause failure and/or
personal injury.
WARNING! DO NOT cut, grind, saw or sand any materials containing asbestos.
DO NOT carry the sander by the hose, or yank the hose from the air supply.
DO NOT get the sander wet or use in damp or wet locations.
DO NOT use the sander with water. These models are dry sanders only.
DO NOT operate sander when you are tired or under the influence of alcohol, drugs or
intoxicating medication.
DO NOT leave the sander operating unattended.
DO NOT carry the sander with your hand on the power lever.
DO NOT direct air from the air hose at yourself or others.
When not in use disconnect from air supply (and dust-free system if connected) and store in a
safe, dry childproof location.
Original Language Version
SA800.V5, SA801.V5 Issue: 1 - 23/07/13
© Jack Sealey Limited
1. SAFETY INSTRUCTIONS