Sealey SM23/2 - Manual

INSTRUCTIONS FOR
SPRAY GUN CLEANER
MODEL NO:
SM23/2.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
R WARNING! Ensure Health & Safety, local authority, general workshop practice regulations are adhered to when using equipment.
R WARNING! Disconnect the air supply from the tank before changing accessories, servicing or performing any maintenance.
 Maintain the tank in good condition (use an authorised service agent).
 Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
 Locate the tank in an adequate working area. Ensure the tank stands on a firm level surface. Keep area clean and tidy and free from
unrelated materials. Ensure the area is well ventilated and has adequate lighting.
R WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure: 30 - 50psi.
 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use, and ensure that all connections are
secure.
 Use only water and detergent as a cleaning agent, do not pour any other type of cleaning fluid into the tank.
 Keep the tank clean. Remove and clean the suction filter regularly for best performance.
R WARNING! Wear approved safety eye protection, mask and gloves.
 Remove ill fitting clothing, ties, watches, rings and other loose jewellery, contain long hair, and wear appropriate protective clothing.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 Keep non-essential persons away from the working area.
 DO NOT use the tank with the lid open and do not use it for spray gun testing.
 DO NOT use the tank for any purpose other than for which it is designed.
 DO NOT operate the tank if any parts are missing or damaged as this may cause failure and/or possible personal injury.
 DO NOT over-fill the tank.
 DO NOT direct air from the air hose at yourself or others.
 DO NOT operate the tank when you are tired or under the influence of alcohol, drugs or intoxicating medication.
 When cleaning is complete, ensure all controls are in the ‘off’ position and that the air supply is turned off.
R WARNING! It is operator’s responsibility to ensure that there is no uncontrolled discharge of any fluids used with this unit and
that appropriate arrangements have been made for correct disposal of waste in accordance with government/local authority
regulations.
2. INTRODUCTION & SPECIFICATION
Fully automatic operation - close lid to start and open lid to stop. Corrosion resistant tank suitable for containing water and detergent necessary for
cleaning water based spray guns. Powerful and reliable piston pump system washes up to two guns simultaneously.
3. ASSEMBLY
NOTE: Item numbers in brackets are those in the attached Parts Diagram. Instructions should be read in conjunction with this diagram.
3.1. Attach legs to cabinet with screws (63), washers (64) and nuts (65) provided and fit drain valve (66) to base of tank (2).
SM23/2.V3 | Issue 3(S) 01/04/15 Original Language Version © Jack Sealey Limited
Operating Pressure: ................................................ 30-50 psi
Air Consumption:........................................................ 2-4 cfm
Weight: ........................................................................ 31.5kg
Cleans: ...........................................................2 pots + 2 guns
Width x Depth x Height: ........................465 x 585 x 1030mm
Wear eye
protection
Wear
protective
gloves
Wear
respiratory
protection
Refer to
instruction
manual